Training

Location:Training / Hot Applications / Industrial Control / Computer Control Technology Wei Qing, National University of Defense Technology / Frequency Sweep Measurement Method for Discrete System Frequency Response

You can log in to your eeworld account to continue watching：
Frequency Sweep Measurement Method for Discrete System Frequency Response
Login

Duration：58 minutes and 49 seconds
Date：2019/04/11

Uploader：JFET

Introduction

keywords： computer control Discrete Systems Status Observation

Computer control technology is an important knowledge intersection of computer hardware series courses and control series courses. The course focuses on studying the differences and connections between continuous control and discrete control. It starts with analyzing computer control system signals and gradually establishes a complete computer control system description, analysis, Design related theories and methods. The course uses MATLAB as a tool and focuses on the training and cultivation of modern engineering capabilities such as control system modeling, analysis and design.

You Might Like

Recommended Posts

Getting Started with the ST SensorTile.box Sensor Kit (2) Getting Started Mode Experience: [i=s]This post was last edited by nich20xx on 2020-6-9 07:17[/i]1 Introduction The Basic Mode of SensorTile.box allows users to experience the SensorTile.box without any programming. After unboxing th; nich20xx ST MEMS Sensor Creative Design Competition

Help with AT89C51 single-chip temperature acquisition design: The sensor measures the water temperature and uses it as feedback to control the heating water temperature (using the PID algorithm). The water temperature can be kept within a stable range and the wa; xuyuesheng110 51mcu

LM3S811 Timer: In KEIL 4 software simulation, when it is in capture timing mode, no matter how the interrupt trigger condition is set, both edges can enter the interrupt. For example, if it is set to falling edge ca; 淮海的大学 Microcontroller MCU

PIC32 code is programmed successfully but does not run: As the title says, the compiler prompts that the programming is successful, but the program does not run, the MCLR pin is always low, all IO ports are high, and the chip is always in reset state. Is t; asdmaill Microchip MCU

430 serial port interrupt mode to receive character string: ////Receive a character//// char Getchar1() //////Function definition??? The return value is char { while ((IFG1&UTXIFG0)==0); return RXBUF0; } //////Receive string #pragma vector=USART0RX_VECTOR __in; 国昊 Microcontroller MCU

Brothers: Has anyone made a 160G hard disk driver for WINCE on an X86 chipset?: Brothers: Has anyone made a 160G hard disk driver for WINCE on an X86 chipset? How can I achieve this? Does anyone have a ready-made solution?; wildaz Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号