Training

Location:Training / Embedded Development / MCU / Punctual Atomic teaches you step by step how to learn STM32-M4 / Serial communication experiment explanation

You can log in to your eeworld account to continue watching：
Serial communication experiment explanation
Login

Duration：28 minutes and 10 seconds
Date：2019/03/21

Uploader：EE大学堂

Introduction

keywords： Microcontroller STM32 Punctual Atom

This video will lead you from the basic to the more advanced to learn the various functions of STM32F4 and start a new STM32 journey for you.
This video is divided into three parts:
1. Introductory part, which mainly introduces the basic knowledge of STM32;
2. Intermediate part, mainly introduces the use of STM32 basic peripherals, including: GPIO, serial port, timer, external interrupt, etc. After studying this article, you will have a basic introduction to STM32 development.
3. Advanced chapter, mainly introduces STM32 advanced peripherals, including: SDIO, CAN bus, etc.

You Might Like

Recommended Posts

Let’s discuss the topic: [i=s]This post was last edited by paulhyde on 2014-9-15 03:38[/i] Everyone should have received the topic, so come out and discuss it; 白丁 Electronics Design Contest

STM8 does not have an analog potential pin Vref; is there any way to replace it?: The STM8 chip has a high cost-performance ratio. I chose STM8S105 and bought a three-in-one development board. Later I found that the chip omitted the Vref pin. This pin is only available in 64-pin pa; wdzywl stm32/stm8

Using LDV4 simulation, the generated waveform is wrong: Add the following set of statements in tb to generate a waveform file. 0000 $ finish ; ncsim > exit ncsim: v04.00.(s005): Started on Dec 10, 2010 at 12:24:34 ncsim -f ncsim.args -messages SIMLOG Loadi; eeleader FPGA/CPLD

WINCE5.0 cross-process injection DLL: I checked online and found that the method of DLL injection under WINCE is different from that under WINDOWS. I have the following questions. Can experts help me answer them? Thank you! 1. Does WINCE; fanfanworm Embedded System

Using MSP430F149 SPI to drive LDC1000, all reads are 0: I use P5 SPI. The program is as follows. I wrote it according to the LDC1000 instruction manual. Did I understand it wrong? The output is either FF or 00. Why? What's wrong? :Sad: #include#define SPI_; Legend丶残羽 Microcontroller MCU

Getting ready to start playing with the MSP430 LaunchPad touchpad: Finally I have some free time. I have been paying attention to capacitive touch for a while. Recently I am going to work on the MSP430 LaunchPad touchpad. Let me share some information first.; ailover2001 Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号