Training

Location:Training / Embedded Development / System Design / Introduction to Computer Science and Programming / Introduction to Computer Science and Programming Episode 08

You can log in to your eeworld account to continue watching：
Introduction to Computer Science and Programming Episode 08
Login

Duration：49 minutes and 29 seconds
Date：2018/08/29

Uploader：老白菜

Introduction

keywords： programming computer

This course is intended for students with little or no programming experience. It strives to provide students with an understanding of the role of computers in problem solving and to help students, regardless of major, become fully equipped with the goal of completing useful small programs. confidence

You Might Like

Recommended Posts

Anyone who has used TLC2543 please come and have a look: When using TLC2543 for AD conversion, if the voltage is measured, should a bypass circuit be added before the analog input channel to remove interference? If so, how should this circuit be connected?; lzcqust MCU

Formal embedded training institution: I don't know why my post disappeared. There are too many embedded training institutions now. Can you comment on Suqian? Does anyone know what Suqian institution is like?; xzl880123 Talking

I don’t understand the monitoring installation plan.: [i=s]This post was last edited by Moshifang on 2014-12-13 16:36[/i] This morning a customer called and asked the factory to install an analog camera. After lunch, I went to check the situation. I was; 莫氏坊 Industrial Control Electronics

【ST NUCLEO-G071RB Review】GPIO: [i=s]This post was last edited by lising on 2019-1-6 14:15[/i] The NUCLEO-G071RB development board used in this experiment is provided by [font=sans-serif][size=4][url=https://www.stmcu.com.cn/index.p; lising stm32/stm8

LPC1114 Debug SSP: Unfortunately, LPC1114 only has one serial port, which is not very convenient to use. Now I adjust the SPI, which is called SSP communication here, to control the wireless chip to send data. It is not; lanyu345 NXP MCU

I have a question: I am a DSP novice, and I have a question for everyone. How can I load my own program into the main program so that it can be called by the main program? Please explain the process in detail, thank you; zhangxp DSP and ARM Processors

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号