Training

Location:Training / Testing and Measurement / Keysight Two-Minute Mentor Series Season 1 / Magical collection mode

Duration：2 minutes and 25 seconds
Date：2018/08/28

Uploader：老白菜

Introduction

keywords： data collection

The Keysight Two-Minute Tutor Series is an introductory course on test and measurement launched by Keysight Technologies, and is delivered by Daniel Bogdanoff, a Keysight Technologies engineer. The main course content of this season is the basic knowledge and operation demonstration of oscilloscope test and measurement, as well as some common oscilloscope application tips and precautions. Mainly include: oscilloscope acquisition mode, triggering incidental signals, ACDC coupling, oscilloscope bandwidth and sampling rate, waveform capture rate, noise, bandwidth limit, jitter measurement, protocol decoding, etc.

You Might Like

Recommended Posts

Design of resistance measurement circuit based on AVR: Please help me design a resistance measurement circuit based on AVR or 51. Thank you very much; yulijie123 Test/Measurement

Temperature measurement system design: [i=s]This post was last edited by paulhyde on 2014-9-15 08:58[/i] I want to design a system that uses ATMEGA32 microcontroller as the core device, AD590 as the temperature measurement sensor, and comp; ning1020 Electronics Design Contest

I'm selling a set of Feiling OK6410D development boards that have been idle for many years. You can sell or exchange them.: I have a set of Feiling OK6410D development board. The ARM11 CPU has a maximum speed of 667MHZ. It seems that the earliest IPHONE was equipped with this chip. It has 128MB of memory and 256MB of flash; jackfrost Buy&Sell

Assembly code function analysis: As shown in the figure, I really can't analyze what this function does, and I can't express it in C:time:; jplzl10000 ARM Technology

An electronic engineering mold supplement used in Visio drawing: A mold supplement for electronic engineering used in Visio drawing, share with you{:1_138:}; #123# Analog electronics

How to get the receiver signal of the remote control of the model aircraft by single chip microcomputer: 1. If you want the MCU to get the signal from the remote control of the aircraft model, do you have to connect the MCU to the receiver of the remote control, and then the MCU should get the signal fro; shijizai 51mcu

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号