• You can log in to your eeworld account to continue watching:
  • Tongji University FPGA course video (24)
  • Login
  • Duration:35 minutes and 42 seconds
  • Date:2016/09/14
  • Uploader:量子阱
Introduction
This course consists of four parts:

The first part is the establishment of VHDL models of various basic digital logic circuits.

The second part is about learning how to design combinational logic circuits, control circuits, and sequential circuits using VHDL.

The third part is the hierarchical structure design of the system chip.

The fourth part is the development of programmable logic devices and the understanding of their structural characteristics.

Lectures by real famous teachers are humanized, just like sitting in a university classroom. Because it is a video tutorial, if you don't understand it for a moment during the lecture, you can watch it over and over again in reverse until you understand it. If you have studied halfway today and want to continue studying tomorrow, you can easily select your own learning progress by fast forwarding. You can work and study at the same time without having to pay expensive school fees and numerous exams.

Each video tutorial lasts approximately 45 minutes. Video teaching has images, sounds, and comes with clear blackboard writing
Unfold ↓

You Might Like

Recommended Posts

How to understand this parameter in the MOS tube specification?
How to understand the SOA curve parameters in the MOS tube specification ? How to read the SOA curve? What does it mean by safe working area ? Can any teacher tell me? Thank you
kal9623287 Power technology
Looking for review questions on new technologies, new services and computer networks for communications engineers (intermediate)
Thank you all, please help me. Please post the question bank if you have one. Thank you very much!
slugx RF/Wirelessly
Why is it necessary to use a four-pin Kelvin connected resistor for current detection?
Why is it said that current detection requires a resistor with four-pin Kelvin connection? --------------https://zhuanlan.zhihu.com/p/78121100Figure 2 shows a resistor with a four-pin structure, with
QWE4562009 Test/Measurement
USB to Serial CH341 Windows Driver
USB to Serial CH341 Windows Driver
songbo MCU
Arria10 configuration issue
I use MAX10 to configure Arria10. MAX10 has an external 512Mbit NorFlash. I use PFL IP to configure Arria10 in MAX10. There is also an ARM bus that can burn Arria10 configuration files into NorFlash.
Neddy11 FPGA/CPLD
Car battery charger, if the two clips connected to the battery are connected in reverse, the bridge current will burn 30A. A reverse diode is recommended
Hello everyone, I have a battery charger at home with a maximum of 30A. The positive and negative poles are divided into red and blue lines. Sometimes, if the positive and negative poles are connected
jinxiang Analog electronics

Recommended Content

Hot VideosMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号