• Duration:50 minutes and 37 seconds
  • Date:2018/02/26
  • Uploader:老白菜
Introduction
Loop Compensation of a Flyback Part 1

Tutorial on how to set the loop compensation, and simulation of a Flyback supply

Loop Compensation of a Flyback Part 2

In this video, we verify the Average mode; (Jack's model) against a Switching model (Basso's model).
Loop Compensation of a Voltage Mode Flyback Part 3
In this video, I show how to use Jack's model to simulate a "Voltage Mode" Forward converter. I show a step-by-step procedure in compensating a second order filter and how to damp the filter. Also show how to use SPICE to display the frequency response of the Ouput Filter and the the Error Amp.
Loop compensation of a Multiple Output flyback Part 4
In this video, I show how to use Jack's model to simulate multiple output flyback.

Unfold ↓

You Might Like

Recommended Posts

Comparison of FPGA reliability among major manufacturers
Q: Using large-scale programmable logic devices such as FPGA or CPLD to improve the reliability of the system, some of these programmable logic devices use anti-fuse technology for programming points.
1ying Automotive Electronics
[RVB2601 Creative Application Development] CDK startup does not respond
Yesterday CDK was closed normally, but today when I open CDK, it has no response, and restarting the computer does not work. I am currently using: Win10Open the log to view:Click Close to view the log
lugl4313820 XuanTie RISC-V Activity Zone
mc52i dial-up problem
Hello everyone: I am using MC52I module now. After configuring the dialing, after ATD*99#, there is no data in the serial port, and NO carrier appears after a while. But when I send ATD*99# directly t
chinatonglian Embedded System
How to use the serial port of Sinlinx A33 development board
ls /dev/ttyS*[/color][/font][color=#4f4f4f][font=-apple-system, "]The development board is connected to serial port ttyS2[/font][/color] Execute: [font=-apple-system, SF UI Text, Arial, PingFang SC, H
babyking Embedded System
Let’s talk about the difference between the neutral wire and the ground wire. If you don’t pay attention, something serious may happen.
[i=s]This post was last edited by maychang on 2016-3-19 08:59[/i] 1. The difference between the neutral wire and the ground wire The neutral wire is grounded at the power supply end (power plant, subs
qwqwqw2088 Analogue and Mixed Signal
Weird switch problem
Hello, everyone:I have a question for you: I am developing in C language in DSPc2000. There are 7 cases in my switch statement. After compiling, I loaded it into DSP. When I used MIX mode to view it,
xtshenyong Analogue and Mixed Signal

Recommended Content

Hot VideosMore

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号