Training

Location:Training / Power Supply / Input filter effect on a power supply using the Vatche Vorperian Model / Input filter effect on a power supply using the Vatche Vorperian Model

Chapter 1：Input filter effect on a power supply using the Vatche Vorperian Model

Duration：7 minutes and 7 seconds
Date：2018/02/26

Uploader：老白菜

Introduction

keywords： filter Power power supply

Follow up to input filter effect on power supplies, In this video, I show a model developed by Dr. Vatche Vorperian. I show how to calculate the negative resistance of a multiple output supply and how to simulate the effects.

Effect of input filter on power supply

You Might Like

Recommended Posts

【Let's play ble+zigbee+6lowpan together! 】—Our TI-CC26xx runs TI-RTOS to light up the LED and LCD: [i=s] 本帖最后由 damiaa 于 2015-12-1 18:39 编辑 [/i]【一起来玩ble+zigbee+6lowpan！】—我们的TI-CC26xx跑TI-RTOS [font=Microsoft Yahei, Hei, Tahoma, SimHei, sans-serif][size=3][b]点亮了LED[/b][/size][/font]Example Summary ---; damiaa RF/Wirelessly

Vivado Learning 2- Custom IP Core: Continue from the previous post Vivado Learning 1- Error in calling and instantiating IP - FPGA/CPLD - Electronic Engineering World - Forum [url=https://en.eeworld.com/bbs/thread-508046-1-1.html]https; suoma FPGA/CPLD

Application of EPS emergency power supply in electrical design: Application of EPS emergency power supply in electrical design According to national standards, power loads are divided into level one, level two, and level three loads according to their importance a; 破茧佼龙 Power technology

Questions about CAN bus: If all nodes on the CAN are isolated, where does the power supply on the bus come from? For example, if I want the logic level on the CAN to be 24V, where does this 24V go?; huo_hu MCU

Doubts about the response of MC55 sending data in GPRS module: Hello everyone, I encountered a problem and was confused when testing MC55. The problem is this: I need the lower computer to transmit data packets to the upper computer through the GPRS wireless netw; SHOWA Embedded System

Are you interested in Lierda's TI development board Cotex-A8 AM1808 development board?: Are you interested in Lierda's TI development board Cotex-A8 AM1808 development board?; whctx DSP and ARM Processors

推荐文章

用于电动汽车的创新EMC滤波器解决方案 2025年01月06日: 随着汽车配备越来越多的电子系统，出现电磁干扰问题的可能性越来越大。这尤其适用于带有用于电机逆变器的附加电力电子设备的电动汽车 (xEV)。EMC 滤波器的使用提供了一种可靠且重量轻的方法来消除密集源的相互干扰。混合动力和全电动汽车（xEV）都装有电子设备，在数量和技术要求上都远远超过内燃机汽车。因为，除了日益复杂的安全、舒适和通信系统之外，真正为电子系统增加赌注的是电力...

研究人员推出无电容固态电源滤波器可用于单相DC-AC转换器 2024年11月13日: 由于电力电子器件的高频工作特性，转换器需要使用关键的无源滤波组件。传统滤波方法采用双电感电容（LC）单元或电感电容电感（LCL）T型电路。然而，电容器容易受到磨损机制和故障模式的影响。（图片来源：CES Transactions on Electrical Machines and Systems）据外媒报道，由普渡大学（Purdue University）电气...

SynQor®宣布推出全新AeroQor®产品系列 2024年10月28日: 该转换器和滤波器设计符合 DO-160G、波音和空客规范 | 适用商用飞机单相和三相隔离功率因数校正解决方案 • 高效率、轻重量、高可靠性 • 出色的功率因数（PF）、总谐波失真（THD）和浪涌特性 • 宽输入和频率范围 • 完全符合 DO-160G、波音和空客标准 • 高水平的文档记录和完全可追溯性 SynQor, Inc. 宣布推出专为商用航空电子设...

共模和差模滤波器方案 2024年10月22日: 引言功率开关器件的高额开关动作是导致开关电源产生电磁干扰(EMI)的主要原因。开关频率的提高一方面减小了电源的体积和重量，另一方面也导致了更为严重的EMI问题。如何减小产品的EMI，使其顺利通过FCC或IEC1000等EMC标准论证测试，已成为目前急须解决的问题。图11 EMI分析具体电路如图1所示。输入为交流220V，经功率二极管整流桥变为直流作为反激变换器的...

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号