logo Training

Live replay: Introduction and application of MPS new generation magnetic angle sensor MA600

Total of 1 lesson ,38 minutes and 48 seconds
Profile

The magnetic angle sensor provides a small-sized non-contact angle detection solution with flexible position design and high reliability. MPS's new generation magnetic angle sensor MA600 is based on TMR technology, which further improves accuracy and dynamic characteristics.

You Might Like

Recommended Posts

2 articles on simulation design in high-speed PCB design
[size=3]Two articles on simulation design in high-speed PCB design[/size]
呱呱 PCB Design
PWM and resistor bank to control LED brightness (made by a novice)
//ICC-AVR application builder : 2006-3-5 20:09:53// Target : M8// Crystal: 4.0000Mhz#include#include#define bitset(var, bitno) ((var) |= (1(bitno)))#define bitclr(var, bitno) ((var) = ~(1(bitno)))#def
songbo MCU
Could you please help me find out which of these two embedded courses is better? Thank you!
I want to go for embedded training. I have seen many training courses and chose these two. However, I don’t understand the specific knowledge of embedded. I beg you to help me! Thank you here! ! ! Fir
zgfjcc Embedded System
What are the turn-on voltage Vt and pinch-off voltage Vp of a field effect transistor? In the output characteristics of the field effect transistor shown in Figures 1.3.3 (a) and (b),
answer: For an enhanced insulated gate field effect transistor (MOSFET), there is no conductive channel at Vgs0, and there is a drain current Id only when Vgs reaches the turn-on voltage V. Therefore,
fighting Analog electronics
Looking for the installation software of IAR V5.30
I have searched for version 5.30 on the Internet for a long time but couldn't find it. I only have a cracker. Can anyone provide me with a V5.30 installation software?
lai430zhuce Microcontroller MCU
2440 bare metal interrupt and MMU problem, please help me analyze it, thank you in advance
I am debugging the interruption of a bare-metal 2440 running in SDRAM. According to my understanding, in order to enter the interruption in SDRAM, the MMU must be enabled so that the memory address 0x
krg_07 Embedded System
Recommended Content
Web users are watching Change

Just Take a Look

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号