logo Training

Live replay: A brief discussion of Microchip’s FPGA products and intelligent embedded vision solutions

Total of 1 lesson ,45 minutes and 8 seconds
Profile

As computing loads shift to edge devices, Microchip's FPGA products consume 30-50% less total power than similar medium-density FPGAs, with static power consumption reduced by 5-10 times, making them a series of emerging computing-intensive edge devices. (including those deployed in thermally and power-constrained environments). Microchip's FPGA intelligent embedded vision solutions cover the entire ecosystem of video, imaging and machine learning IP and tools, helping to quickly develop high-performance products commonly required in markets such as industrial, healthcare, broadcast, automotive, aerospace and security. , various designs with low power consumption and compact packaging.

You Might Like

Recommended Posts

Puzhong Technology 51 MCU Development Board v3.0 Dynamic Digital Tube Part
#include typedef unsigned char u8; typedef unsigned int u16; u8 smgduan[16]={0x3F, 0x06, 0x5B, 0x4F, 0x66, 0x6D, 0x7D, 0x07, 0x7F, 0x6F, 0x77, 0x7C, 0x39, 0x5E, 0x79, 0x71}; // Segment selection u8 sm
gbjkjku MCU
Why can't the SPI digital isolation chip ISO7241A on the DRV8301demo board work?
As the title says, I recently used TI motor driver demo board DRV8301 to develop motor driver, which requires SPI communication. After the software writes the SPIA program, the output signal TX needs
lYB Analogue and Mixed Signal
Please help me with the problem of vxworks hung
This is a simple taskwhile(1) { _tv.tv_sec = 0; _tv.tv_usec = time; /* If using 10000 us, then the system hang will not occur. */res = select(0, NULL, NULL, NULL, _tv); if (res0errno != EINTRerrno !=
lyl19 Real-time operating system RTOS
STM32F103 timer clock not understood
Today I saw a blog post that says: Assuming the system clock is 72Mhz, TIM1 is derived from PCLK2 (72MHz), and TIM2-7 is derived from PCLK1. The key is to set the clock pre-division number and the val
ddllxxrr stm32/stm8
51 MCU serial communication problem
There is no serial port protocol between the upper and lower computers. When one side is ready to receive, the other side can send. Now the question is how can the receiver know that the data stream h
manly88 Embedded System
Jlink debugging often shows "could not transfer JTAG data"
When running naked, I debugged with ADS and this problem occurred after running for a few minutes. The time is not fixed, sometimes a few minutes, sometimes more than ten minutes. But if it is burned
wangjunaza Embedded System
Recommended Content
Web users are watching Change

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号