Some data say that most op amps can be powered by either single or dual power supplies, except for those that can only be powered by dual power supplies unless otherwise specified.This is the "offset
[i=s] This post was last edited by Qiufeng Streetball on 2021-3-26 13:24[/i]I have always wanted to have an oscilloscope. In March, Keysight Technologies had a Thanksgiving Month event live broadcast
I need to amplify a sine wave signal of about 1mV to collect its frequency. I use AD620+active bandpass filter+OP07 amplification for signal acquisition. At present, after the second-level active filt
As shown
The input Uin of the op amp is obtained from the -380VDC bus through resistor voltage division to obtain -3.5VDC
Is the op amp in the figure a simple inverting 1:1 amplifier circuit, or is it