Blackfin UART Example-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

[ESP32-Audio-Kit Audio Development Board Review] Part 3 play_mp3_control
1. Prerequisites The premise for implementing the contents of this section is that the official ESP-IDF framework and ESP-ADF framework of Espressif have been successfully compiled. Here we use the es
PCB manufacturing experience summary (2)
[i=s]This post was last edited by 18379433374 on 2019-3-7 10:46[/i] [size=5][color=#00bfff][b]This sharing is based on [url=https://en.eeworld.com/bbs/type-68-79-1.html]PCB Production Experience Summa
[Telink B91 Universal Development Kit] Questions about the functions of TX and RX on the burning tool
In the previous post (https://en.eeworld.com/bbs/thread-1219308-1-1.html), the program was successfully downloaded using the burning tool. Only the GND and SWM pins were used.In addition to these two
FPGA Design Process
FPGA Design Process
Power supply obstacles + power supply SBC selection and pitfalls
Hello everyone, I am an automotive electronics hardware engineer. When selecting a power SBC, you should pay attention to the battery voltage range and then combine it with the test standards to selec
Sharing of key points on the use of ADI passive components
Four design considerations for telematics hardware in connected cars
Wide voltage input USB-C, 5V/3A output adapter reference design
When the machine is turned off, the LDO output is normally 3V. Why does the voltage reach 3.5V after the machine is turned on? What is the reason?
【Smart Sports Watch】3. Build Development Environment 2

Trending Downloads

Blackfin UART Example

Document Introduction