Please help me, the software is altium designer19
1 I am clearly connected, but why am I still seeing "Un-Routed Net Constraint: Net xxx Between Pad xxx"?2Net Antennae (Tolerance=0mil) (All)Net Antenn
[i=s]This post was last edited by Yaojishanchuan on 2021-3-30 15:01[/i]If you want to run a program at startup, you need to edit the "/etc/rc.local" file on the development board and add the command y
This section talks about external interrupts.
Read the introduction and understand the program is the best way
External interrupt is the lowest priority interrupt of MSP430 and it is a maskable in
[i=s]This post was last edited by elec32156 on 2020-6-28 16:41[/i]I would like to ask about the electrostatic protection of the device. The device is connected to 220V AC power. There is a 220V to 24V