Hardware: MCU: MSP430F149Crystal: 32K, 8MInput signal: 10ms low level, 7.5ms high level received via wireless,Input port: P4.0 (TB0)Requirement: Capture the pulse width of the low level
Software:1. In
I used CPLD to make an AES/EBU audio decoder. I used a 50MHZ crystal oscillator as a counter to count. I decoded the data stream based on the counter size. I used a sine wave as the source. The peak-t
This section attempts to describe the structure of P2G hardware and software at a certain level.
Regarding the hardware composition and a rough introduction of Position2Go, the official provides two A
Why does the tens digit flash after this program is written into the microcontroller, but yours does not? Please give me some advice, thank you #include
#define uchar unsigned char #define uint unsign