I want to display the clock icon and light bulb icon as shown above.
But I can't find any 16*16 dot matrix editing software.
Can anyone help me, what should I do? Thank you!
Hi everyone, I'm looking at the datasheet of an audio chip. At the end of the document there are some PCB layout suggestions for reducing ESD and EMI. It says:
“Address, Data, Chip select, Reset signa
The DSP development software integrates a program that can convert the executable file OUT to a format acceptable to the programmer, so that the programmer can use this file to burn EPROM or Flash. Th
[i=s]This post was last edited by Eurasia32 on 2022-7-31 00:06[/i]TSC (Touch Sensor Control)The TSC of N32WB452 supports capacitive touch function, with a maximum of 18 channels, and each channel can
Usually the common mode inductor in a switching power supply is located at the position shown in the figure below.
Now we take power from an independent winding of a transformer, and perform DCDC step