Hardware Design of Single Chip Microcomputer Display-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

How to dynamically open the Bluetooth kernel log for the Allwinner V853 chip?
**1. Topic** How to dynamically open the log of the Bluetooth kernel **2. Problem background** Product: Tina product such as scanning pen Hardware: V853 + XR829 Software: Tina linux4.9 The purpose is
Regarding the problem of leakage current when the MOS tube is not completely turned off
The circuit diagram of this part is as shown in the figure. The signal generator PULSE generates a +4V square wave signal, and the driver IC1 converts it into a +18V square wave signal and outputs it
Detailed explanation: ground wire and power wire
Part 1: Basic design principles for basic power supply and groundNoise on ground and power linesThe ideal ground resistance is zero, but in reality the ground always has a certain impedance. Especiall
EEWORLD University - Introducing the SimpleLink? MCU Platform
Introduction to SimpleLink? MCU platform : https://training.eeworld.com.cn/course/4998
In a battery-powered low-power product, the ADS/DIR/open-drain/pull-up/pull-down settings of each port pin
I would like to ask: In a low-power battery-powered product, in addition to shutting down the internal module functions and clocks when not needed, how should the ADS/DIR/open-drain/pull-up/pull-down/
Introduction on how to encapsulate functions into libraries
Basic principles of PCB anti-interference design
TI Action Camera and Handheld Stabilizer Solutions
【micropython】ESP32 enables built-in hardware SD/MMC controller
Free review: APM32E103VET6S MINI development board with the highest performance of the JIHAI M3 core is here

Trending Downloads

Hardware Design of Single Chip Microcomputer Display

Document Introduction