After unpacking, we need to build a basic development environment for development and testing. After checking the information, we found that it uses the NRF52833 chip open CPU architecture. So we need
[i=s]This post was last edited by yhye2world on 2019-12-17 14:39[/i]As shown in Figure 1 and Figure 2:Two double-sided boards, dimensions as shown.
Excuse me, are the charges for these two PCBs the sa
Question 14 : 1. Figure (06) is a typical application circuit in the UC1525A manual. Transformer T1 has two secondary windings, which are used to drive a half-bridge circuit. If a full-bridge circuit
Does anyone know how to connect and use the Omron E6A2 cable? I didn't buy it on Taobao (I applied for it) so I can't find any information. Urgently needed