-
STM32F767 PWM wave problem
I recently developed a program to drive a stepper motor with PWM wave using STM32F767. The PWM wave is generated by the PB0 pin of timer 3. [backcolor=rgb(222, 240, 251)]The manual says that TIM3 is 1
-
GPIO module of C6000 series DSP
When doing video transmission between DSP and FPGA, the communication method used is EDMA. For the sake of system introduction, data transmission between DSP and FPGA is realized through EDMA.
First,
-
【NUCLEO-L552ZE Review】+ Based on FREERTOS transplantation
I've been playing with the L552 board recently, and suddenly I wanted to use FREERTOS. I wanted to port it myself, but when I looked online, I found that most of the posts were based on the porting of
-
Share analog electronics experience
[i=s]This post was last edited by Jacktang on 2022-1-6 13:15[/i]What is the most widely used power amplifier circuit at present?
Answer: The most widely used power amplifier circuits at present are OT
-
Application Challenges of NB-IoT Standard
1. The NB-IoT standard has four major characteristics : First, wide coverage, which will provide improved indoor coverage. In the same frequency band, NB-IoT has a gain of 20dB over the existing netwo
- Questions about hardware circuits
- Toshiba stepper motor driver chip TB5128FTG free sample
- How to change the value of serial input data and then output it in VHDL?
- RC Circuit Waveform
- [ESP32-S2-Kaluga-1 Review] 2. Run littlevgl?