When developing DSP, you need to configure its underlying hardware and peripherals accordingly. Only after the configuration is completed can you activate its corresponding modules and then write and
Constant current source, constant voltage source, voltage drop after MOS is turned on
1. This is a very classic constant current circuit. The load current is only controlled by the op amp's in-phase i
[align=left][font="]Attach the download link first[/font]https://ezchina.analog.com/thread/18608[/align][align=left] [/align][align=left] [/align][align=left][font="]Due to the excellent power and pow
Conference Introduction
With the vigorous development of the Internet industry, the data traffic generated by data centers has become an important part of communication network traffic. As an importan
UART polling mode is much simpler than interrupt mode. The UART initialization code is as follows:
Copy code1 voidUARTInit(void)2 {3 // Configure UART1 parameters4 // Baud rate 115200 data bits 8 stop