PTC thermistor for EMC device design-Power Management-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Amplification issues of differential amplifiers
Theoretically, the amplification factor should be 330 times. When 0.1A current flows through the sampling resistor R5, the output should be around 3.3V. Why is the output always around 4.7V when using
New design approach improves smart meter performance
After the mature smart grid is built, smart meters will have the functions of automatic query and remote meter reading, and can also realize automatic power off. However, at present, domestic smart me
How to view NPU clock power configuration and information for Allwinner V853 chip?
[KERNEL_DIR]/arch/arm/boot/dts/sun8iw21p1.dtsi ``` npu: npu@03050000 { compatible = "allwinner,npu"; reg = ; device_type = "npu"; dev_name = " npu"; interrupts =; clocks = clk_npu, clk_pll_npux4; cloc
USB PD fast charging communication principle
[i=s]This post was last edited by qwqwqw2088 on 2021-6-25 09:59[/i]The charger circuit based on the PD protocol can keep the AC/DC part unchanged, but replace the QC protocol controller with a PD cont
[Project source code] Audio recording and playback system based on FPGA WM8731
[i=s]This post was last edited by Xiaomeige on 2020-2-6 15:48[/i]/*Functional description:Use the audio codec chip WM8731 on the AC620 development board to complete audio acquisition, storage and play
[National Technology N32G430] 3. Timer
How to obtain CCS License from TI
The semiconductor industry is facing a cold winter. What do you think?
Announced: ST Sensor Transplantation Competition + Bone Vibration Sensor Evaluation Results
Single Channel Sonar Receiver - Active Butterworth Filter

Trending Downloads

PTC thermistor for EMC device design

Document Introduction