I am a power supply novice. Recently, my teacher asked me to make a digital buck circuit. I used a signal generator to generate the pwm signal. After I finished, I found that the gate of the pmos tube
I have just started working on motor drivers. Do you have any good learning materials or learning experiences? Thanks for the guidance of all the seniors.
[i=s]This post was last edited by qwqwqw2088 on 2020-9-24 08:29[/i]question:
Use the LM2611 chip to convert 5V to -5V to power the op amp. Refer to the circuit design in the manual.The actual designed
As an excellent supplier in the semiconductor field, ADI also has diversified development in medical electronics, including prevention, diagnosis, treatment and disease management.In the prevention st
[backcolor=rgb(222, 240, 251)]Recently I have been tinkering with the left and right blind spot cameras of the car. The cameras have been installed and use a 4.3-inch folding display. The left and rig