[i=s]This post was last edited by wadeRen on 2022-1-27 10:37[/i] # [Article Navigation] [GD32L233C-START Review——01. Unboxing, Development Kit](https://en.eeworld.com/bbs/thread-1192154-1-1.html "GD32
The previous post introduced the interface design and implemented the interface test through software simulation, which basically met expectations. This post introduces adding hardware support and imp
1. First adjust the jumper cap of the development board. As shown below2. Download the burning software
地址【https://occ.t-head.cn/community/download?id=4014051462874206208】
The software name is [CSKY-F
U1A is powered by positive power, U2A is powered by negative power, Input-signal is the input signal, the signal is positive and negative, the frequency is lower than 1K, and the amplitude meets the i
When DSP SCI uses FIFO to send interrupts, it cannot generate interrupts when configuring the FIFO depth. When matching the interrupt trigger bit, the interrupt is not triggered. What is going on?