OPTO-TOUCH photoelectric button-Electron circuit-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

SensiML Industrial Monitoring Demo ST SensorTile
Looking for a chip that drives multiple indicator lights
The microcontroller is 5V, but many indicator lights are 24V. Most indicator lights have a current of 10~100MA, and there are usually more than 10 of them. I often use optocouplers + transistors to sw
TI's latest generation of ultra-low power multi-protocol chip ZigBee/6LoWPAN/BLE/Thread chip CC2652
Chip Introduction CC2652R Protocol stack download, CC2652RDevelopment board, CC2652 LaunchPad Development environment, CCS 7.4, Our first complete release ofSimpleLink Zigbee SDK Pluginis now availabl
This RF article is interesting - interpreting the empirical rules of foreigners for microwave circuits
Interpreting the Foreigners' Rules of Experience for Microwave Circuits Disclaimer: The article to be interpreted comes from a foreign paper. Some of the individual interpretation points are quite int
In the LM5118 datasheet, Application and Implementation section, "Minimum load current (CCM operation) = 600mA", what does it mean?
[i=s]This post was last edited by yhyworld on 2019-11-20 16:38[/i]See Figure 1,LM5118 specification, 8.2.1 Design Requirements, minimum load current (CCM operation) = 600mA. Figure 2 is Figure 19 ment
Autonomous low-power Tesla coil "Experimental"
What medium is used to start the pins when they are all low level?
Is ADI technology still here?
Hot topic: 2019 College Entrance Examination: What impact will the arrival of the 5G era have on the college entrance examination and universities?
12/06 @Shanghai World Peace Group ADAS-NXP S32V in-depth technical seminar invites you to participate!

Trending Downloads

OPTO-TOUCH photoelectric button

Document Introduction