[i=s]This post was last edited by nemon on 2019-6-24 02:35[/i]First of all, I have to apologize. There were some special circumstances in February. I didn't arrange the time well and didn't gather all
There is really nothing to write about the assembly of McQueen, because it is too easy. Install the wheels, plug in the ultrasonic sensor, and finally connect the battery box. McQueen uses 3 AAA batte
[i=s]This post was last edited by cruelfox on 2019-1-13 19:27[/i] Still using the online IDE, I added a BLE Characteristic module to the project I had already experimented with, and connected the acce
First upload the source packageThe development board uses the DAP tester, so use DAP-RTT. There is also Jlik_RTT, which you can use by yourself.
DAP——RTT software (in the source code package, just unz
As shown in the following figure, the left side is the read timing diagram of STM32 FSMC mode A, and the right side is the read timing diagram of SRAM. From the figure, STM32 can only set the tRC time