How to choose a suitable pull-up and pull-down resistor for open-drain output-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

[AB32VG1 development board review] TF card and file reading and writing applications
The AB32VG1 development board is equipped with a TF card slot, and its interface is shown in Figure 2. When a TF card is inserted, file-level operations can be performed with the cooperation of the fi
How to measure power supply rejection ratio?
I want to make a curve between the power supply rejection ratio and frequency, but I don’t know how to measure it?
280049Solution to the problem of LaunchPad emulator not being able to connect
To use F280049C, you need to install a higher version of CCS, because the lower version does not support the relevant hardware library. Therefore, I installed CCS8.0. Before installation, it is best t
Tips for Powering FPGAs
Oops. I connected a field programmable gate array (FPGA) to the output of a DC/DC converter and now the DC/DC won't start. When I look at the circuit with an oscilloscope, I see what's shown in Figure
[TI recommended course] #[High Precision Laboratory] Interface: 1 RS-485#
//training.eeworld.com.cn/TI/show/course/5506
What is the use of connecting Schottky diodes in parallel at both ends of the MOS tube used as a switch at the power input?
Friends in Xi'an, please get out of this pit as soon as possible.
Xianyu low-cost wireless digital microphone disassembly (Jerry solution)
[Perf-V Review] + Solidification of Hummingbird Soft Core
Read the good book "Electronic Engineer Self-study Handbook" + my impression

Trending Downloads

How to choose a suitable pull-up and pull-down resistor for open-drain output