Verilog Tutorial

2014-01-19
5.22MB
Points it Requires : 10

Download

repReport

Document Introduction
You Might Like
Recommended Downloads

Verilog Tutorial

unfold

Recommended ContentMore

Open source project More

Popular Components

Searched by Users

Just Take a LookMore

Configuration and use of TI C2000 TMS320F28379D SCID SCIB
TI's official routines only give the configuration of SCIA and not the configuration methods of other SCIs. In fact, the configurations of these are the same. The following takes the configuration of
Low-power multi-protocol chip ZigBee/6LoWPAN/BLE/Thread chip CC2652
Chip Introduction CC2652R Protocol stack download, CC2652R SDK, http://www.ti.com/tool/simplelink-cc26x2-sdk Development board, CC2652 LaunchPad, http://www.ti.com/tool/LAUNCHXL-CC26X2R1 Development e
Share a STLINK V2_1 PCB project, which can be directly sampled and produced
[i=s] This post was last edited by Tongxiaokaocode on 2019-6-11 23:56[/i]Share a PCB project of STLINK V2_1, which can be directly sampled and producedSupport SWD mode, with virtual serial port, suppo
3. [Learning LPC1768 library functions] External interrupt experiment
Only P0 and P2 of LPC1768 have interrupt function. These two ports share interrupt line 3, which can be configured as rising edge trigger or falling edge trigger. What is rising edge? What is falling
Please advise on the design of driving circuit for inductive load
[i=s] This post was last edited by aallian on 2019-12-19 21:32 [/i] I want to make a device that converts DC power into magnetic energy. The input voltage is +DC12V/4A, and the load is a set of coils.
DAC8552 of MSP430F5529 microcontroller
FPGA network port communicates with PC
Package placement issues
Radio Books
Wireless low power interruption problem: After MSP430 enters the low power LMP3 mode, the wireless module of the IO port analog communication cannot connect...

Trending Downloads

Verilog Tutorial

Document Introduction