-
How do I design a circuit with such input and output?
1. There are signals in and out, and there may be a clk. When in changes from low level to high level, out should output high level immediately. No matter how in pin changes, out should not change. Ho
-
Board burning problem
Every time the program of the board is changed, the board must be powered off, then powered on again, and the program must be burned again before it can run. This is inconvenient. Are there any improv
-
X-NUCLEO-IKS01A3 driver for Arduino
Well, I participated in an event and was given a board for free, but the prerequisite was to debug and port it to an MCU, so I wrote the Arduino UNO. Then after I got it, I found that ST actually wrot
-
Nexperia Award-winning Live Broadcast: Introduction and Application of Automotive Power MOSFET and GaN Devices in Electric Vehicles
Nexperia Award-winning Live Broadcast: Introduction and Application of Automotive Power MOSFET and GaN Devices in Electric VehiclesClick here to enter the live broadcastLive broadcast time: October 18
-
Nordic Bluetooth sensor monitors guitar temperature and humidity
Recently launched on the forumDevelopment competition based on ON Semiconductor's low-power Bluetooth chip RSL10, 10,000 yuan gift
Some netizens want to participate, but feel that Bluetooth has run ou
- EEWORLD University Hall - Altium Designer 22 Electronic Design Introduction Practice 56 Lectures
- ztool cannot connect
- IEEE Spectrum Top Programming Language Rankings April 2022
- ADS1278 data acquisition chip data distortion problem
- Could you please advise what is wrong with this circuit?