For USB program, low pass filter for audio, Audio low-frequency Pass filter.

Recommended ContentMore

Open source project More

Searched by Users

• USB to TTL-CP2102 driver
• Microchip LLC principle analysis and design guidance (AN1495a)
• Analysis of APC drive circuit of semiconductor laser diode
• Manchester codec, Manchester Verilog code, provided by Xilinx
• FAT32 file system function library for microcontrollers using C language to create system files
• STM32F103C8T6 MCU minimum system schematic diagram
• Microwave Engineering (Fourth Edition) (David M.Pozar)
• ARM Embedded System Basic Tutorial.pdf
• USB Mass Storage Device_5.1.2600.0
• FDTD method to calculate the band gap of photonic crystals

Just Take a LookMore

• CMOS and TTL
  1.TTL level: output high level2.4V, output low level0.4V. At room temperature, the general output high level is 3.5V, and the output low level is 0.2V. Minimum input high level and low level: input hi
• STM32 Cube study notes (16 articles)
  The learning content is as follows:Download STM32 Cube study notes (all 16 articles)
• 3D Printer Controller Project Report
  [i=s]This post was last edited by caxfan on 2022-11-5 20:28[/i]#3D Printer Controller ProjectcaxfanIntroduction A project based on the open source 3D printer system Smoothieware V2.0 ported to STM32F7
• STM32 HAL library UART interrupt reception issue
  I generated the interrupt code for UART1 using STM32CubeMX.The interrupt code is generated in the file stm32f0xx_it.c. To verify whether an interrupt occurs, I use the uart_irq variable to indicate th
• Encryption chip comparison
  Data description: There are so many encryption chips on the market that people are dazzled. This article analyzes and compares the encryption chips of various manufacturers. "Whether it is a mule or a
• 3 RTC configuration and timed wake-up
• Altium Designer 18 official tutorial Chinese and English version
• Selection requirements for electromagnet freewheeling diodes
• How to measure and solve voltage sag problems?
• EEWORLD University Hall----TIDA-01040 High Current Battery Test Equipment Reference Solution

Trending Downloads

• Design of Microcomputer Control System for Electric Saw Testing
• ch5a.ppt
• Research and implementation of USB+20+OTG+IP core host driver based on LINUX
• USB Firmware (Assembly Version
• Creative design and practice of robots
• 【NXP】TFA9887: Audio system with adaptive sound exciter and speaker protection
• 74LS series complete information.
• A very good e-book for others to refer to, especially for beginners.
• The most complete chip packaging collection
• Write a compiler principle lexical analyzer in C language, which is simple to implement.