Pseudo-random sequence generation and analysis procedures

Pseudo-random sequence generation and analysis programs, under Matlab, can be run directly after decompression, very easy to use.

unfold

Recommended ContentMore

Open source project More

Popular Components

Searched by Users

Just Take a LookMore

Failed to install seafile server on Raspberry Pi 3B+arm processor
[color=#222222][font=Helvetica, Arial, sans-serif][size=14px]I installed seafile-server_6.2.5 on Raspberry Pi 3B+, Raspbian system. After entering the name, IP address or domain name, data storage dir
DSP product development process steps
1. Development environment CCS (CodeCo 　　mposerStudio) is a complete DSP integrated development environment developed by TI. Since TI's DSP is widely used, CCS has become one of the most widely used D
【RPi PICO】Use PIO to get more Sigma Delta ADC inputs
From: https://forum.micropython.org/viewtopic.php?t=9839p=55065#p55065The ADC input channels on PRP2040 are relatively few. The following method can provide more ADC channels. Each channel requires 2
Ti's DSP program is programmed in C++
[size=4]In embedded development, older developers are more accustomed to using C language; and young people are also taught in C language when they are learning. In fact, using C++ for embedded develo
Questions about STLINK programmer
I want to ask if the STLINK programmer can provide 5V and 3.3V voltages, is it because it has a built-in step-down module? Also, do you usually use the programmer like the one in the picture below?
Questions about C language.
【GD32E231 DIY】Human infrared detection (EXTI)
I can't find the CC2640R2F official demo on my phone or SimpleLink Starter.
FPGA Three Kingdoms
Will GaN's advantages in the RF field keep it popular?

Trending Downloads