Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
It is divided into two layers. One layer is the interrupt controller inside each core, which is called interrupt controller, abbreviated as intc; the other layer is for the entire chip, which is chip-...
The development board for this evaluation: ESP32-Audio-Kit
Provider: Ai-ThinkerQuantity: 10 piecesApplication period: now to August 16Application Methods:
Click here to enter the event page and fill i...
Recently, I have been working on a product powered by lithium batteries. The general requirements for the power supply are as follows:
1. Powered by a single rechargeable lithium battery;
2. The board...
[align=left][color=rgb(88, 88, 88)][font=Verdana, "]World Peace Group (WPI) and Jiehe Technology will jointly hold the "World Peace Group (WPI) / Jiehe Technology GDSM Visual Retail Summit" at the Ham...
[align=left] [font=宋体]Design of frequency meter[/font][/align][align=left] [font=宋体]Frequency measurement generally includes[/font] [font=宋体]direct frequency measurement method[/font] [font=宋体]period ...
Looking back at 2019, it was really sadder than ever. My mother was sick and spent the New Year in the hospital. I spent the entire holiday taking care of her in the hospital. I couldn't help but feel...
According to the project requirements, you can use I/O external pull-up to drive the digital tube; you can also use 74HC138 (38 decoder) + 74HC245 (8-way signal transceiver) to drive the digital tube...[Details]
Recently, Littelfuse, a manufacturer of circuit protection, power control and sensing technology, announced its third quarter financial report ending September 26, 2020: Sales were $391.6 million, ...[Details]
The British government is expected to conduct an in-depth investigation into Nvidia's planned $40 billion acquisition of ARM due to antitrust and national security concerns, according to the Sunday T...[Details]
The nRF51822 is a powerful, highly flexible multi-protocol SoC that is ideal for Bluetooth? low energy and 2.4GHz ultra-low power wireless applications. The nRF51822 is built on a 32-bit ARM? Cort...[Details]
Common measuring instruments used by electricians include megohmmeters, multimeters and clamp-on ammeters. If these instruments are not used correctly or are slightly negligent during measurement, the...[Details]
Recently, GEM Co., Ltd. (hereinafter referred to as GEM) and PT HALAMAHERA PERSADA LYGEND (hereinafter referred to as HPAL), a subsidiary of Ningbo Lygin Resources Technology Development Co., Ltd. ...[Details]
An uninterruptible power supply is mandatory on oil rigs: For safety reasons, signal lighting must be functional at all times. R. STAHL was faced with three major challenges when designing an uni...[Details]
0 Introduction
With the promotion of liquid crystal displays and the rapid development of liquid crystal backlight module technology, the market demand for liquid crystal displays is not only ...[Details]
Generally, all MCU timers used for ordinary timing functions need to have the following elements: 1. Time base: The time base is the clock source of the timer, which is usually derived from the int...[Details]
Since the outbreak of the novel coronavirus pneumonia epidemic, the Northeast Branch of State Grid Corporation of China has conscientiously implemented relevant requirements to ensure the safe and ...[Details]
In 1968, the former Soviet scientist VESELAGO analyzed the propagation characteristics of electromagnetic waves in a medium with negative dielectric constant ε and magnetic permeability μ based on Max...[Details]
According to foreign media TechRader, Fujitsu has detailed the FUJITSU-MONAKA (hereinafter referred to as MONAKA) processor, which is scheduled to be shipped in 2027.
The MONAKA CPU is based o...[Details]
Easy-to-use and reliable ICeGaN™ HEMT ICs now available in Asia Pacific August 08, 2023 Cambridge, UK - Cambridge GaN Devices (CGD) is a fabless environmental technology semiconductor company tha...[Details]
The typical MCS-51 microcontroller has four bidirectional 8-bit I/O ports, denoted as P0, P1, P2, and P3. Each port consists of a port latch and an input buffer /output driver. The following figure s...[Details]
Temperature sensors are instruments for measuring temperature and are widely used in industry, scientific research, medical treatment and other fields. This article will introduce in detail the mea...[Details]