-
In order to realize the signal conversion needs without the computer system, this paper proposes a bus signal conversion design based on CO2128 and DSP, and gives the hardware and software design m...[Details]
-
Recently, the National Development and Reform Commission and the National Energy Administration issued the "Notice on Actively Promoting the Work Related to Subsidy-free Grid-parity Access of Wind ...[Details]
-
In industry, voltage 0-5(10)V or current 0(4)-20mA is usually used as a method for analog signal transmission, which is also a method often used by programmable controllers. So what are the differe...[Details]
-
When the watchdog timer overflows, a reset pulse with a duration of 1 CK cycle is generated. At the falling edge of the pulse, the delay timer starts counting tTOUT. See below for the specific operat...[Details]
-
Noise can severely impact sensitive current measurements. Both the source impedance and source capacitance of the DUT affect the noise performance of the SMU.
The source impedance of the DUT affects...[Details]
-
The single chip microcomputer source program for controlling the 28BYJ-48 stepper motor driver is as follows: #include reg52.h #include intrins.h unsigned char CCW ={0x80,0xC0,0x40,0x60,0x20,0x...[Details]
-
TrendForce's subsidiary, TrendForce Research Institute, recently released the list of the world's top 10 wafer foundries in the second quarter of 2019. Affected by the overall market decline, the rev...[Details]
-
1. What is ADC 2. Characteristics of STM32ADC The number of ADC bits determines the accuracy of ADC, which can be 8-bit, 12-bit, 16-bit, etc. Another very important parameter is the conversio...[Details]
-
O Introduction
Test equipment is one of the most important subsystems in a weapon system. Whether it works properly or not will directly affect the combat performance of the entire weapon syste...[Details]
-
introduction
Ubiquitous networks have brought huge development opportunities to network access devices. With the rapid growth of the network access market, embedded network access has begun t...[Details]
-
1 Introduction
In the secondary system of power plants and substations, a reliable DC power supply is required to power control, protection, automatic devices, emergency lighting and other equipmen...[Details]
-
With the development of industrial automation, intelligence and informatization, data exchange and communication between industrial equipment have become increasingly important. Efficient data inte...[Details]
-
There are usually two types of small liquid flow meters, Hall flow meters and photoelectric flow meters. The Hall flowmeter uses the Hall effect to place an impeller with a two-pole magnet perpend...[Details]
-
In order to solve these problems of distributed EEA, automotive engineers have gradually begun to integrate many ECU functions with similar and separate functions into a processor hardware platform...[Details]
-
To jump from assembly to C you must use an absolute jump:
Project code:
Add main.o to Makefile:
Start.S:
Make compile:
Main.c code:
#...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD