VCC is equal to 5V, and the input Vi is a small sinusoidal signal (for example, the signal is 0~1V). How to adjust this circuit (if one transistor is not enough in the circuit, you can add another one...
[i=s]This post was last edited by Aguilera on 2020-10-11 20:49[/i]Configurable Logic Blocks (CLBs) reduce overall system cost and increase functionality by integrating external logic into C2000 microc...
In this flyback power supply, the X pin is used for current limiting, and the V pin is used for overvoltage detection. When nothing is set, there is no voltage output at the output end of C16 when the...
[i=s]This post was last edited by Gen_X on 2021-9-25 11:22[/i]I have never learned C and started directly with STM32-CUBE. I felt good all the way.
Many experts and seniors have left messages saying t...
Humidifier, buzzer, lighter...it turns out that their principles are here → Classic experimental cases of power amplifiers (1) Piezoelectric ceramic drive!Experiment name : Piezoelectric ceramic drivi...
In circuit design, we usually only care about the quality of the signal. Due to the limitations of simulation analysis software, SI simulation research is often limited to signal lines, and the power ...