Moisture Sensitivity Level (MSL) – This product is Hermetically Sealed
and not Moisture Sensitive - MSL = N/A: Not Applicable
Pb
RoHS/RoHS II
11.5 x 5.0 x 3.5 mm
| | | | | | | | | | | | | | |
FEATURES:
• High reliability & Low Cost
• Tight stability & extended temperature
•
Proven resistance welded metal package
APPLICATIONS:
• Home electronics
• Computers, modems, and communications
• High-precision TCXO and clock applications
• Microprocessors
STANDARD SPECIFICATIONS:
Parameters
Frequency Range
Minimum
3.579545
3.579545
Operation mode
24.01
24.01
Operating Temperature
Storage Temperature
Frequency Tolerance
Frequency Stability over the Operating
Temperature ( ref. to +25°C)
Equivalent series resistance (R1)
Shunt capacitance (C0)
Load capacitance (CL)
Drive Level
Aging @ 25°C per
year
Insulation Resistance
Drive Level Dependency (DLD,
Minimum 7 points tested: from 1µW to
500µW)
0
-55
-50
-50
See table 1 below
7
18
100
500
±10
25% of Max
ESR
Max ESR in
Table 1
1000
±5
Typical
Maximum
70
24.0
70.00
50.00
+70
+125
+50
+50
ºC
ºC
ppm
ppm
Ω
pF
pF
µW
ppm
MΩ
ppm
Ω
Ω
MHz
Fundamental AT-
cut (Standard)
3
rd
OT AT-cut
(Standard)
Fundamental AT-
cut or BT-cut (See
options)
See options
See options
See options
Units
Notes
See options
@ 100Vdc ± 15V
Δfrequency
(Max –
Min)
ΔESR
(Max – Min)
Max ESR over DLD
range
Table 1
Frequency (MHz)
3.579 - 4.999 (Fund.)
5.000 - 5.999 (Fund.)
6.000 - 7.999 (Fund.)
8.000 - 8.999 (Fund.)
9.000 - 9.999 (Fund.)
10.000 - 15.999 (Fund.)
16.000 - 50.000 (Fund.)
24.01 - 31.999 (3rd O/T)
32.000 - 70.00 (3rd O/T)
ESR(Ω) max.
180
120
100
80
60
50
40
100
80
ABRACON IS
ISO 9001 / QS 9000
ISO 9001:2008
CERTIFIED
Revised: 01.08.13
30332 Esperanza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-8001
| www.abracon.com
Visit www.abracon.com for Terms & Conditions of Sale
HC/49US (AT49) MICROPROCESSOR CRYSTAL
ABL Series
(Left blank if standard)
Pb
RoHS/RoHS II
11.5 x 5.0 x 3.5 mm
| | | | | | | | | | | | | | |
OPTIONS AND PART IDENTIFICATION:
ABL -
Frequency in MHz
Please specify the frequency
in xx.xxxxMHz.
e.g. 14.3181MHz
Load Capacitance (pF)
Please specify CL
(Minimum 10pF) in pF or
S for series
Custom ESR if other
than standard
R□
□:
Specify a value in
Ω
(e.g.: R40)
MHz -
-
-
-
-
-
Packaging
Blank: Bulk
T: Tape & Reel
TRAY: Tray
Value Added
I
Insulator Tab
L2
Middle 3rd lead
QXX
Trimmed leads
Q15
for 0.15" length
Oscillation Mode
F: Fund. AT>24MHz
FB: Fund. BT>24MHz
Operating Temp.
A: -10°C ~ +60°C
B: -20°C ~ +70°C
C: -30°C ~ +70°C
N: -30°C ~ +85°C
D: -40°C ~ +85°C
J*: -40°C ~ +105°C
K*: -40°C ~ +125°C
L*: -55°C ~ +125°C
Freq. Tolerance
H5: ± 5 ppm
1: ± 10 ppm
7: ± 15 ppm
2: ± 20 ppm
3: ± 25 ppm
4: ± 30 ppm
Freq. Stability
U**: ± 10 ppm
G: ± 15 ppm
X: ± 20 ppm
W: ± 25 ppm
Y: ± 30 ppm
H: ± 35 ppm
Q: ± 100 ppm
R: ± 150 ppm
NOTE:
* Frequency stability ±50ppm, ±100ppm, ±150ppm only. Contact ABRACON for tighter frequency stability.
** -10 to +60C only.
ABRACON IS
ISO 9001 / QS 9000
ISO 9001:2008
CERTIFIED
Revised: 01.08.13
30332 Esperanza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-8001
| www.abracon.com
Visit www.abracon.com for Terms & Conditions of Sale
HC/49US (AT49) MICROPROCESSOR CRYSTAL
ABL Series
OUTLINE DRAWING:
L
5.5mm Min
20.0 ± 0.5mm
Packaging
Bulk
Tape & Reel
Pb
RoHS/RoHS II
11.5 x 5.0 x 3.5 mm
| | | | | | | | | | | | | | |
ABL SERIES HC49/US (AT49)
MICROPROCESSOR CRYSTAL
Date of Issue: Jan. 2
nd
, 2013
Page (8) of (10)
8.0
Packaging:
T= Tape and reel (1,000pcs/reel)
L
11.5 x 5.0 x 3.5 mm
Abracon Drawing # 450667
Revision #: T
Dimensions: inch (mm)
TAPE & REEL:
T= Tape and reel (1,000pcs/reel)
Dimensions: mm
ATTENTION:
Abracon Corporation’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applica-
tions. Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where
component failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and
authorization from Abracon Corporation is required. Please contact Abracon Corporation for more information.
ABRACON IS
ISO 9001 / QS 9000
ISO 9001:2008
CERTIFIED
Revised: 01.08.13
30332 Esperanza, Rancho Santa Margarita, California 92688
tel 949-546-8000
|
fax 949-546-8001
| www.abracon.com
Visit www.abracon.com for Terms & Conditions of Sale
Why is it said that current detection requires a resistor with four-pin Kelvin connection? --------------https://zhuanlan.zhihu.com/p/78121100Figure 2 shows a resistor with a four-pin structure, with ...
Live broadcast time: 2:00-3:30 pm, August 24 (Tuesday)Live broadcast topic: How to design high-performance servo drives using Infineon IGBT7Presentation document: Click here to downloadWatch replay: C...
In the first open source license ruling to be heard by an Italian court, a software vendor has lost a civil case for failure to comply with open source license requirements. On December 13, the Court ...
In the latest update, examples of using user C/C++ modules have been added to the MicroPython source code, making it easier to add your own functional modules.stm32: Support C++ code and user C module...
I have a circuit that needs to use 3.3V to power the sensor. I use TPS7A88 to stabilize the voltage at 3.3V, and then pass it through a 0603 1 ohm resistor and then connect it to a Murata 0805 47uF ca...
0. Introduction
With the industrial control industry's pursuit of energy efficiency and control accuracy, and based on the application of wide bandgap semiconductor devices, the switching spee...[Details]
summary TLV320AIC3204 (AIC3204 for short) is an ultra-low power stereo audio codec. Due to its excellent audio quantization, processing performance and ultra-low power design, it is widely used ...[Details]
Since its launch, Advantech's WISE-PaaS industrial IoT cloud platform has been committed to empowering industrial IoT solution providers and accelerating the digital transformation of various industr...[Details]
Citing a report from The Florida Independent, Microsoft is planning to acquire MicroVision and is expected to officially announce the news later today (May 12). MicroVision is a leader in ultra-micro...[Details]
For most manufacturing companies, automatic data collection of measuring instruments has always been a troublesome issue. Even if the instruments have RS232/485 and other interfaces, they still use th...[Details]
In the early days of industrial process control, industrial devices (sensors and actuators) were individually connected to programmable logic controllers using dedicated wires carrying analog (4-20...[Details]
I wanted to dismantle this cat toy before, but never did it. Today I happened to have it in my hand, so I just used a screwdriver to dismantle it~
I have the 1300 R model, and the function...[Details]
Introduction: This chapter will describe how to configure GPIO and how to configure UART STM8 project template: http://download.csdn.net/detail/u012388993/9904051 The basic system configuration ...[Details]
The serial port of the 51 microcontroller is a programmable full-duplex communication interface with all the functions of UART (Universal Asynchronous Receiver/Transmitter). It can send and receive da...[Details]
What is SmartStart%26;#8482;? If the battery voltage is > 4.1V when the phone is turned on, it will enter standby mode (the battery will not be charged). If the battery voltage is later lower than 4.1...[Details]
It was previously revealed that Qualcomm SM8450 will no longer be called Snapdragon 898, but will be named Snapdragon 8 gen1, and MediaTek has renamed the "Dimensity 2000" chip and officially release...[Details]
Tesla's dominance in the U.S. electric vehicle market is facing a growing threat as rival Rivian has raised $1.3 billion in funding, bringing its total funding in 2019 to $2.8 billion. Rivian, an A...[Details]
(1) Hardware Circuit Using the 4-digit LED digital tube display circuit, a clock circuit with a 24-hour or 12-hour cycle display can be made, and the clock can be manually preset at the starti...[Details]
The best evaluation standard for PLC programs is practice. See whether the program can achieve the expected purpose. But this is not enough. Because there are good and bad programs that can achieve...[Details]
1. Overview
CNC (Computer Numerical Control) machine tools are automated machine tools controlled by computer programs and are widely used in metal processing, mold manufacturing and other fie...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD
