POWER
Data Sheet
Total Power:
120-960 Watts
Input Voltage:
380-480 Vac
# Outputs:
Single
SPECIAL FEATURES
Slim form factor
Five year warranty
High efficiency up to 94%
Full power at 60 °C
Power Boost™
Industrial grade design
• Metal case
MTBF > 500,000h
Adjustable output
Overvoltage protection with
auto recovery
Continuous short circuit and
overload protection
New visual diagnostic LED
Three Status LEDs
• Input
• Output
• Alarm
DC OK relay
Parallel operation capability
Screw terminal connections
RoHS compliant
No tools required for mounting
ADN-C Series 3-Phase
120-960 Watts
Electrical Specifications
Input
Nominal voltage
AC input range
DC input range
Frequency
Efficiency
PFC
Phase input
380 - 480 Vac
320 - 540 Vac
450 - 760 Vdc for ADN5, ADN10 & ADN20
50 - 60 Hz
Up to 94%
Active power factor correction for ADN20 & ADN40;
meet EN61000-3-2 Class A
ADN5 and ADN10 will operate with single phase input at 100% load
Derate to 75% and 50% for ADN20 and ADN40 respectively under loss
of 1 phase; Units will shut down if thermal threshold is exceeded under
this condition
24 V (24.0 - 28.0 Vdc Adj.)
> 20 ms for ADN5, ADN10 & ADN20; > 15 ms for ADN40
< ± 2% overall
< 100 mVpp
PowerBoost™
2x nominal current for < 2 sec for ADN5 & ADN10;
1.5x nominal current for 4 seconds minimum while holding voltage > 20 Vdc
for ADN20 & ADN40
Single or parallel operation selectable via front switch. For redundant
operation use of external diode module is preferred;
ADN40 uses active paralleling
< 35 V
> 30.5 Vdc, but < 33 Vdc, auto recovery
Output
Nominal voltage
Hold-up time
Voltage regulation
Ripple
Current limit
Peak current
SAFETY
UL508, cULus Listed
UL 60950-1, cURus 2
nd
edition
IEC60950-1 2
nd
edition
Class I, Div 2 Hazardous Locations
IP20
CE
Parallel operation
Power back immunity
Overvoltage protection
ADN-C Series 3-Phase Data Sheet
General Specifications
EMC emissions
EMC immunity
EN61000-6-3:2001, Class B EN55011, EN55022 Radiated and Conducted including Annex. A, EN61000-3-2
EN61000-6-1:2001, EN61000-6-2:2001, EN61000-4-2 Level 4, EN61000-4-3 Level 3, EN61000-4-6 Level 3,
EN61000-4-4 Level 4 input and level 3 output. EN61000-4-5 Isolation class 4, EN61000-4-11, Semi F47 sag
immunity
5 Years
Protected against continuous short-circuit, overload, open-circuit. Protection Class 1 (IEC536), degree of
protection IP20 (IEC 60529) Safe low voltage: SELV (acc. EN60950)
Visual: 3 status LEDs (Input, Output, Alarm)
Relay: SSR or dry relay contact, signal octive when Vout = 18.5 vdc + 5%
Warranty
General protection safety
Status indicators
LED Diagnostics
LED
Input
Output
Alarm
OK
Green
Green
---
Loss of Ac
---
---
---
Low Ac
Yellow
Green
---
No Dc
Green
---
Red
High Load
Green
Yellow
Yellow
Overload
Green
Yellow
Red
Hot
Green
Green
Yellow
Too Hot
Green
---
Yellow
Environmental Specifications
Storage/shipment
Operation (convection)
Humidity
-40 °C to + 85 °C
Full Load -25 °C to + 60 °C derate to 50% load at +70 °C
Up to 50% load permissable with horizontal or on top mounting orientation
< 90% RH, non-condensingl IEC 60068-2-2, 68-2-3
Other Features
Fusing
Mounting orientation
Ventilation
Cooling spacing
Input externally fused; output not fused, output is capable of providing high currents (PowerBoost) for motor
load startup
Standard: Vertical, Optional: Horizontal or on Top
Simple snap-on to DIN TS35/7.5 or TS35/15 rail system
Normal convection, No fan required
ADN5: 15 mm in front, 25 mm above and below
ADN10: 15 mm in front, 25 mm above and below
ADN20: 25 mm in front, left and right; 70 mm above and below
ADN40: 15 mm in front, 70 mm above and below, 25 mm left and rightt
Input: Screw terminals, connector size range: 16-10 AWG (1.5-6 mm
2
) for solid conductors
Output: Connector size range: 16-10 AWG (1.5-6 mm
2
) for ADN5, ADN10 and ADN20 solid conductors; 6-7
AWG for ADN40
Connections
ADN-C Series 3-Phase Data Sheet
Ordering Information
Model Number
ADN5-24-3PM-C
ADN10-24-3PM-C
ADN20-24-3PM-C
ADN40-24-3PM-C
Power
120 W
240 W
480 W
960 W
Input Voltage
320 - 540 Vac
450 - 760 Vdc
Weight
1.15 lbs (520 g)
1.54 lbs (700 g)
2.8 lbs (1300 g)
5.3 lbs (2400 g)
Current
5 A @ 24 Vdc
10 A @ 24 Vdc
20 A @ 24 Vdc
40 A @ 24 Vdc
Efficiency
85.0%
91.2%
93.0%
Case Type
MTBF
> 500,000 hours
Nominal voltage,
full load,
Tamb=25
o
C
Metal
320 - 540 Vac
94.0%
Dimensions
Height
ADN5-24-3PM-C
ADN10-24-3PM-C
ADN20-24-3PM-C
ADN40-24-3PM-C
4.85 in (123 mm)
4.85 in (123 mm)
4.85 in (123 mm)
4.85 in (123 mm)
Width
1.97 in (50 mm)
2.36 in (60 mm)
3.34 in (85 mm)
7.09 in (180 mm)
Depth
4.36 (111 mm)
4.36 (111 mm)
4.68 (119 mm)
4.85 in (123 mm)
Mechanical Drawing
W
D
+
+
-
Input
Output
Alarm
-
OK
24 VDC / 20 A
24 - 28 Vd c
Single
Parallel
H
ADN20-24-3PM-C
C
U
L
US LISTED
380 - 480 V3; 3W + PE 50/60 Hz
0.9 A / Phase
L1 L2 L3
W
D
H
ADN40-24-3PM-C
C
U
L
US LISTED
Continuous
Mode
Reset fuse
mode
Input:
3PH 380/500 VAC
1.7/1.5A/Phase 50/60 Hz
Parallel
Use
Si
ngle Use
Output:
24 VDC / 40 A
Electronically Protec ted
Overload
Fuse Mode
L1 L2
L3
+ -
OK
WORLDWIDE OFFICES
Americas
2900 S.Diablo Way
Tempe, AZ 85282
USA
+1 888 412 7832
Europe (UK)
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
+44 (0) 1384 842 211
Asia (HK)
14/F, Lu Plaza
2 Wing Yip Street
Kwun Tong, Kowloon
Hong Kong
+852 2176 3333
www.artesyn.com
For more information:
www.artesyn.com/power
For support:
productsupport.ep@artesyn.com
ADN-C Series 3-Phase DS 15Jun2017
Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and
service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names,
trademarks, or registered trademarks of their respective owners. Specifications are subject to change without
notice. © 2017 Artesyn Embedded Technologies, Inc. All rights reserved. For full legal terms and conditions,
please visit www.artesyn.com/legal.
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
