If industrial robots want to avoid collisions in a large area ( brother, don't touch porcelain for no reason ), they need to be able to sense in all directions ( up and down, left and right ). TI mill...
I designed a circuit using the TPS73033 linear step-down chip. When the load is disconnected, the output voltage is normally 3.3V. After the load is connected, the output voltage drops to 0.7V. There ...
PWM signal is a digital signal with a fixed period and variable duty cycle.
If the counter of Timer_A works in up-counting mode, the output adopts output mode 7 (reset/set mode)
Use register TAxCCR0 t...
This article mainly describes the use of Zero-Knowledge ESP8266 and MPU-9250 to obtain speed, gyroscope angle, and geomagnetic data.1. HardwareZero-Knowledge ESP8266nine-axis sensor: MPU-9250Dupont wi...
[i=s] This post was last edited by Fei Yang Zi Ji on 2019-2-15 22:10 [/i] [size=4] During the New Year, our village holds a ceremony where all married girls return home to worship their ancestors. [/s...
Flash is a memory that can be electrically erased and written online, and the information will not be lost after power failure. It has the characteristics of low power consumption, large capacity, ...[Details]
By David Katz
Rick Gentile
Analog Devices
Many general-purpose signal processors have good computational performance and basic connectivity features that make them acceptable for industr...[Details]
Overview
In spectral measurement, photomultiplier tubes (PMT) and charge-coupled devices (CCD) are often used as photoelectric converters. PMT is used in slow-changing, high-precision spec...[Details]
In 2010, the Civil Aviation Administration of Shandong Air Traffic Control Branch reported to the Shandong Provincial Radio Management Office that the frequency 122.900MHz of the VHF ground-to-air com...[Details]
Although the power innovations of various manufacturers are somewhat influenced by Volkswagen's "golden combination", Ford is probably the only one that can compete head-on. In the past few years...[Details]
1. I2C bus and its virtual application 1. I2C bus application calls platform mode At present, the peripheral expansion of single-chip microcomputer application systems has transitioned from a paralle...[Details]
Although the lights-off event of "Earth Hour" has passed, people are still thinking about turning off lights. Some media said that turning on an energy-saving lamp once is equivalent to turning on ...[Details]
This article was written by Paul McLellan, a Cadence technical expert Arm recently held the 2020 Arm DevSummit, which was hosted by Arm CEO Simon Segars. In his opening remarks, he briefly discusse...[Details]
People need electronic devices with high efficiency, low power consumption and energy efficiency compliance, as well as wireless systems with higher performance and smaller form factors, which poses a...[Details]
Author: Markus Gruber is R&D Manager and TSN expert at Congatec What makes today’s factories different from the past is that connected industrial devices are expected to communicate directly with e...[Details]
Tile, best known for its range of Bluetooth-based tracking accessories that compete with AirTags, announced today that it will be acquired by location tracking service Life360. Tile will continue t...[Details]
This morning I wrote the I2C hardware interface program of atmega16. The program is not difficult, just to give beginners an idea. However, by comparing it with the software simulation I2C program of ...[Details]
The 2024 All Energy Australia Australian International Energy Exhibition opened grandly today at the Melbourne Convention and Exhibition Center.
Sofar New Energy made a shining appearance at bo...[Details]