Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
I have done a simulation of a BOOST circuit.Why is it that when the circuit starts working, the inductor current is in continuous mode, but becomes discontinuous mode after a period of time?...
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:59[/i] As an important part of this year's Electronics Expo, the "2006 China Consumer Electronics Innovation Summit Forum and China Con...
[i=s]This post was last edited by RCSN on 2019-1-6 14:32[/i] [font=宋体][size=5] I have to say that Infineon's peripherals are really rich, and sometimes you need to read the user manual to understand t...
[i=s]This post was last edited by dcexpert on 2020-10-8 10:38[/i]This time, the LED effect display is taken out separately, and various effects can be programmed, it all depends on everyone's creativi...
[i=s]This post was last edited by Hechuanxin on 2022-6-14 10:32[/i]It has been more than four years since the mass production of gallium nitride chargers. The price has also gradually become more affo...
This article is a diode charging circuit. In order to be able to change the operating frequency arbitrarily without causing changes in the charging voltage, a blocking diode is introduced into the ci...[Details]
Take the Tektronix TDS2000 series oscilloscope as an example #1 Digital Storage Oscilloscope Glossary 1. Digital is relative to analog, converting continuous analog signals into discrete digital si...[Details]
introduction
Electric boilers can directly convert electrical energy into thermal energy. They have the advantages of high thermal efficiency, small size, no pollution, low noise, safe and reli...[Details]
As a parent, I often feel that children in this Internet age are lucky because they have the best life and learning experience. Take learning for example, if a child has an all-round learning machine...[Details]
3 Design of compensation filter As can be seen from Figure 3, the amplitude-frequency characteristic curve of the CIC filter is not flat in the passband, and the signal is attenuated in the passband....[Details]
As the supply voltage of digital circuits in electronic systems drops to the 1.0 - 1.5V range, and power consumption on load boards increases, DC/DC converter modules need to provide very high outpu...[Details]
Multiple media outlets reported that a report released by Strategy Analytics showed that in February 2020, Xiaomi's global shipments exceeded Huawei, ranking third after Samsung and Apple. ...[Details]
Prioritization: 1. The highest priority: not really an operator () Symbols that change priority (parentheses), Grou PIN g operator Array subscript operator Array a CC ess () function call...[Details]
introduction
DVI is the abbreviation of Digital Visual Interface. In the field of embedded electronics, high-definition interfaces such as DVI are increasingly used. Many embedded products use H.264...[Details]
introduction
At present, the measurement range, measurement method and measurement accuracy of most temperature acquisition cards on the market are fixed at the factory. The measurement meth...[Details]
Not long ago, the ongoing Huaxizi scandal made the term "domestic products" the focus.
Old domestic brands such as Fenghua and Huoli 28 have been on the hot search list one after another, ...[Details]
Abstract: An asymmetric half-bridge DC/DC converter using complementary PWM control is introduced. The steady-state process of the circuit and the ZVS process of the switch are analyzed, and the co...[Details]
1. The four terminals of the current transformer must be connected according to the wiring diagram. Otherwise, the indication of the energy meter will be wrong or even reversed;
2. When connected thr...[Details]
1 Characteristics of the development of optical fiber technology 1.1 Network development puts forward new requirements for optical fiber The next generation network (NGN) has triggered many opi...[Details]
Power technology
京公网安备 11010802033920号
EEWORLD
