Tight stability (0.3 ppm) over wide industrial temperature range
(-40 °C to +85 °C)
V, 3.3 V and 5.0 V versions
3.0
Wide frequency range 8-52 MHz
Low phase noise
Excellent G-sensitivity performance: 1.5 ppb/G
Tri-state function
Applications:
WiMax
base stations
Military
and Avionics
Point
to point / multi-point radios
Test
and measurement and medical equipment
WLAN
GPS
Frequency
synthesis, frequency translation and land mobile radio
Corporate Headquarters
100 Douglas Avenue
PO Box 630
Yankton, SD 57078-0630
1-800-762-8800
www.mtronpti.com
MtronPTI
Applications Note
HCMOS/Clipped Sinewave TCXO/TCVCXO – 3.0/3.3/5.0 Volt – 5x7 mm
M611x Series
MtronPTI’s M611x Series TCXO’s and TCVCXO’s provide design engineers with low voltage, surface
mount products with extremely tight stability (to ±0.3 ppm) over temperature and time. Specially pro-
cessed crystals enable the M611x to achieve consistent long-term stability and minimal frequency shift
after reflow. Our processing also enables us to achieve excellent g-sensitivity (1.5 ppb/g). The low phase
noise (-155 dBc/Hz at 100 kHz) makes the M611x ideal for those design engineers working on all types
of systems as the reference timing source.
The M611x Series is ideally suited for a wide range of applications such as GPS, military, avionics, test and
measurement, WLAN, WiMax base stations (see Fig 2.), point to point/multi-point radios, medical equip-
ment, frequency synthesis, frequency translation and land mobile radio.
Standard output for the M611x series is HCMOS compatible or clipped sinewave and draws as little as 1.5
mA with a 3.3 volt supply at 13 MHz. This low power consumption provides an advantage over similarly
specified ovenized oscillators for power-sensitive applications.
The M611x series offers ±9.2 ppm minimum pull range with excellent tuning linearity performance for criti-
cal PLL applications. This series is available in frequencies from 8 to 52 MHz, and is offered in a ceramic
surface mount platform with industry standard 5 x 7 mm footprint.
Figure 1. Typical Test Circuit
Figure 2. WiMax Subscriber Station
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
Please see
www.mtronpti.com
for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI
1-800-762-8800.
2
M611x Series
HCMOS/Clipped Sinewave TCXO/TCVCXO – 3.0/3.3/5.0 Volt – 5x7 mm
Product Features:
•
•
•
•
•
•
Product Specifications
Tight stability (0.3 ppm) over wide industrial temperature range (-40 °C to +85 °C)
3.0 V, 3.3 V and 5.0 V versions
Wide frequency range 8-52 MHz
Low phase noise
Excellent G-Sensitivity performance: 1.5 ppb/G
Tri-state Function
Description:
MtronPTI’s M611x Series TCXO’s and TCVCXO’s provide design engineers with low voltage, surface mount products with
extremely tight stability (to ±.3 ppm) over temperature and time. Specially processed crystals enable the M611x to achieve
consistent long-term stability and minimal frequency shift after reflow. Our processing also enables us to achieve excellent
g-sensitivity (1.5 ppb/g). The low phase noise (-155 dBc/Hz at 100 kHz) makes the M611x ideal for those design engineers
working on all types of systems as the reference timing source.
Applications:
•
•
•
•
•
•
•
WiMax base stations
Military and avionics
Point to point / multi-point radios
Test and measurement and medical equipment
WLAN
GPS
Frequency synthesis, frequency translation and land mobile radio
Ordering Information:
Part Number Example:
M611x
1
J
T
C
N
40.000000MHz
Part Number Example: M6111JTCN – 40.000000 MHz
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
Please see
www.mtronpti.com
for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI
1-800-762-8800.
3
M611x Series
HCMOS/Clipped Sinewave TCXO/TCVCXO – 3.0/3.3/5.0 Volt – 5x7 mm
Performance Characteristics:
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
Please see
www.mtronpti.com
for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI
1-800-762-8800.
4
M611x Series
HCMOS/Clipped Sinewave TCXO/TCVCXO – 3.0/3.3/5.0 Volt – 5x7 mm
Product Dimensions & Pinout Information:
Handling Information:
Although protection circuitry has been designed into the M611x TCXO/TCVCXO, proper precautions should be taken
to avoid exposure to electrostatic discharge (ESD) during handling and mounting. MtronPTI utilizes a human-body
model (HBM) and a charged-device model (CDM) for ESD-susceptibility testing and protection design evaluation.
ESD voltage thresholds are dependent on the circuit parameters used to define the mode. Although no industry-
wide standard has been adopted for the CDM, a standard HBM (resistance = 1500, capacitance = 100 pF) is widely
used and therefore can be used for comparison purposes. The HBM ESD threshold presented here was obtained
using these circuit parameters.
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
Please see
www.mtronpti.com
for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI
TI helps you design your power supply!EMI (Electromagnetic Interference) - A critical factor that is becoming increasingly important in electronic systems, especially in applications such as automotiv...
We use the command "vi Makefile" to enter the Makefile. As shown in Figure 1:Add the following content.Change TARGET to "key" in line 2.Add the GPIO and key driver header file path to the variable INC...
[i=s]This post was last edited by jinglixixi on 2022-2-16 12:08[/i]The GD32L233C is equipped with a corresponding temperature detection channel, and the on-chip temperature can be detected with the he...
At the beginning of this year, a large-scale power failure occurred in Texas, and large areas of the country were hit by a power outage.
Nowadays, human life is very dependent on electricity, whether ...
[NXP Rapid IoT Review] Rapid IoT Studio Simple Programming Step 4 Add Bluetooth RGB Light Control [font="]1. Add RGB light control control to the Rapid IoT Studio Simple Programming Step 2 Counter Add...
[i=s]This post was last edited by szkei on 2020-8-14 22:41[/i]First, the previous article used the LCD library function to display the Olympic five-color rings and the pictures of Hetai evaluation. Po...
The world has been suffering from Arm and x86 for a long time, and the industry has placed its hope in RISC-V, saying that now is the era of "three-thirds of the world". As a descendant of the inst...[Details]
Variable Frequency Drive (VFD) and Servo Drive are two common motor drive devices. They have different characteristics and uses in practical application scenarios. This article will introduce the d...[Details]
1. What is an external interrupt? External interrupts are interrupts generated by external level or rising and falling edge triggers. 2. Register Introduction External interrupt mainly sets three reg...[Details]
1. Understanding LCD1602 Liquid crystal display is referred to as liquid crystal or LCD. Various types of liquid crystal are usually named according to the number of rows of displayed characters or t...[Details]
1. Before using the multimeter, you should perform "mechanical zero adjustment"; 2. During the measurement process, do not touch the metal part of the test lead with your hands to ensure both accu...[Details]
Although the vast majority of Apple products are assembled in China, Apple's contract manufacturer Foxconn also assembles Apple iPhones in some other countries. Now, Foxconn has begun producing ...[Details]
(1) MCS-51 is the mainstream product. (2) MSP430 has strong functions. It is a Flash microcontroller with ultra-low power consumption. It is mainly used in three-meter and ultra-low power consumptio...[Details]
The LED display screen in use suddenly has garbled characters due to signal problems. If it happens at a major opening ceremony, the loss is irreparable. Therefore, how to improve the reliability a...[Details]
The mid-term facelift Mercedes-Benz E-Class (W213) was released on March 3, 2020 Beijing time. Due to the spread of the "new coronavirus" epidemic, this year's Geneva Motor Show in Switzerland was fo...[Details]
Application of interrupts and digital tubes - "9999" countdown table #include reg52.h unsigned char code LedChar ={//Numbers displayed by the digital tube 0~9 0XC0,0XF9,0XA4,0XB0,0X99,0X92,0X82,0...[Details]
A clamp ammeter is also called a clamp meter. It is a special instrument for measuring AC current. It is generally used in situations where the current is measured without disconnecting the circuit. ...[Details]
Temperature monitoring is an important link in industrial production. Especially in industrial sites with harsh and complex environments, temperature monitoring plays an irreplaceable role. However, ...[Details]
Main factors affecting system power consumption
For a digital system, its power consumption roughly satisfies the following formula: P=CV2f, where C is the system's load
capacitance
, ...[Details]
1. Introduction
With the development of online video platforms, users' demand for 4K high-definition quality is growing. However, many users have found that even if they have purchased m...[Details]
Power technology
京公网安备 11010802033920号
EEWORLD
