-
The attacker has no direct access to the AI model and only indirect access to the sometimes encrypted software in the target ECU
Sometimes confusing (supplier's property protection)
...[Details]
-
In the automotive field, silicon carbide (Sic) is ushering in its moment of glory. It is understood that silicon carbide is currently used in the models of many car companies such as Tesla, BYD, We...[Details]
-
When designing the 8051 microcontroller application system, programming often requires directly operating the various memory address spaces. The object code generated after the C51 program is compi...[Details]
-
High-brightness LEDs are increasingly being used in lighting applications. Here we present a simple "mood light" using only a few components. All three LEDs are powered by a constant current using ...[Details]
-
Introduction to PIC Microcontroller C Language Programming
The biggest advantage of using C language to develop microcontroller system software is high code writing efficiency, intuitiv...[Details]
-
Voltage type burnout:
Tools: Use a 15V power supply to connect a 47~470 ohm small resistor (not too small), connect a diode-protected light-emitting tube in parallel, and connect the light-emit...[Details]
-
1. Main program
#include "sys.h"
#include "usart.h"
#include "led.h"
#include "lcd.h"
#include "delay.h"
#include "remote.h"
#include "stm32f10x_tim.h"
/*
Program function: Use the timer i...[Details]
-
Push-pull inverter
Circuit
Diagram
VT2 is turned on, the voltage polarity of the same-name terminals of the two windings on the primary side of the transformer is positive...[Details]
-
1. Acceleration
In a broad sense, it refers to the reaction that is accelerated by adding certain accelerators to various chemical reactions. In a narrow sense, it refers to the treatment react...[Details]
-
5G number release time postponed. Recently, the operator financial website exclusively learned that the 5G commercial number release time of the three major operators has been postponed to before Sep...[Details]
-
The program source code is as follows: /* 4 digital tubes display 0~3 in a cycle */ #include reg51.h typedef unsigned char uint8; typedef unsigned int uint16; code uint8 LED_CODE = {0xC0,0x...[Details]
-
Infrared remote control technology is a technology that uses infrared rays to transmit instructions. It is widely used in many fields such as household appliances, toys, security, military technolo...[Details]
-
Why are electric motors above 4kW connected in a delta connection?
The main purpose is to reduce the load current. In general, high-power motors are connected in a triangle.
Under the sam...[Details]
-
Oscilloscope basic block diagram The measured signal ① is connected to the "Y" input terminal, and after being properly attenuated by the Y-axis attenuator, it is sent to the Y1 amplifier (preampl...[Details]
-
In the previous section, when I set up to disable the watchdog, I set WTCON to 0 and masked the interrupt. As shown below:
This section is to mask the interrupt register:
The follow...[Details]