-
Driver source code:
#include "linux/module.h"
#include "linux/kernel.h"
#include "linux/fs.h"
#include "linux/init.h"
#include "linux/delay.h"
#include "linux/irq.h"
#include "asm/uacce...[Details]
-
On September 15, Baidu World Conference 2020 opened today. Baidu founder Robin Li and CCTV host Kang Hui talked about smart transportation and future driving experience on the spot. Robin Li predic...[Details]
-
Sine wave phase shift circuit with fail-safe protection
a Sine wave phase shift circuit with sharp pulse
b Sine wave phase shift circuit with safe sine wave voltage
...[Details]
-
An investor asked a question on the investor interaction platform: It has been more than a month since Mr. Dong's last visit to the platform to answer questions. Why didn't Mr. Dong pay attention to ...[Details]
-
Introduction:
With the development of power electronics, the application scope of inverter control technology and industrial field bus is becoming wider and wider. This system successfully applies...[Details]
-
Several principles for energy saving or power saving rate
1) There are certain conditions for frequency converter to save power. Under the condition that it does not affect the use, after changing...[Details]
-
Recently, according to official news from Woyan Capital, Beijing Kehua Microelectronics Materials Co., Ltd. (hereinafter referred to as "Kehua Microelectronics") received an investment of 170 million...[Details]
-
2013 will be the year when affordable LED lamps for mass lighting will compete in design, production and listing. The price-performance ratio of affordable LED lamps for mass lighting will determine ...[Details]
-
In any
switching power supply
design, the physical design of the PCB board is the last step. If the design method is not appropriate, the PCB may radiate too much electromagnetic interferen...[Details]
-
6.1 include/conskfigs/micro2440.h
Add
#define CONFIG_CMD_NAND_YAFFS
【illustrate】
When I was reading cmd_nand.c, I found that u-boot-2011.03 already supports yaffs writing. I ...[Details]
-
Sensors and the ML inference results output by these sensors are the important core of autonomous assisted driving. Mixel and Ram bus explained this transmission technology MIPI at MI PI DevCon, in...[Details]
-
The serial port interrupt configuration of STM32 is also very simple.
The first step is to configure the UART GPIO port
The first step is to configure the UART GPIO port
/**********************...[Details]
-
TOKYO, June 12 – Toshiba Electronic Devices & Storage Corporation (“Toshiba”) today announced that driver assistance systems in Toyota Motor Corporation’s (“Toyota”) vehicles, which use the company’...[Details]
-
Introduction: The stm8_interrupt_vector.c file will not be automatically generated when developing under IAR, but it will be generated under STVD, and the interrupt vector table _vectab will be gener...[Details]
-
1 Introduction
The digital multimeter measures resistance by measuring the voltage Vx generated by the constant current source I flowing through the measured resistor RX. The digital value of R...[Details]