-
When debugging the motor driver, you cannot use interrupts to check some registers or data casually. Otherwise, if the duty cycle is large, the MOS tube may be burned directly. Therefore, in many ...[Details]
-
1. Concept of interruption 1. Carefully study what is interruption? For example: a student is doing homework in the classroom, and is suddenly called out. After returning, he continues to do his ho...[Details]
-
MCU Assembly Language Programming
1. Write a program to use bit processing instructions to implement the logical function of "P1.4 = P1.0 ∨ (P1.1 ∧ P1.2) ∨ P1.3".
MOV C,P1.1 ANL C,P1.2 ORL C,P1.0...[Details]
-
On April 15, developer kacskrz discovered a new version of MIUI called "MIUI Go", which is used for entry-level phones with less than 4GB of memory. According to XDA, MIUI Go will be applied ...[Details]
-
The circuit breaker has a simple principle, few parts and is easy to maintain. When replacing parts, attention should be paid to the reliability of the parts and the parameters should meet the requir...[Details]
-
Note: The operation commands of the microcontroller's off-chip program memory and data memory are different from the commonly referred to memory, and are different from the AT24C02 of the I2C bus a...[Details]
-
An efficient and sophisticated building and energy management system should include the ability to automatically record the owner's electricity, gas and water usage, which not only reduces costs ...[Details]
-
1. Install minicom
sudo apt-get install minicom
Second, configure minicom
1. Run minicom
sudo minicom
2. Press Ctrl + a, release, and then press o. The configuration ...[Details]
-
Welding robot motion control refers to the control of the posture, speed, position and other parameters during the welding process by controlling the way the welding robot performs motion, so as to...[Details]
-
Kenan Cha, Vice President of VeriSilicon Machine Learning Software and Neural Network Processor Products, introduced the VeriSilicon Neural Network Processor at the Khronos·VeriSilicon Technology Sem...[Details]
-
The microcontroller source program is as follows: #include reg52.h #define uchar unsigned char #define uint unsigned int #define DAdata P0 //DA data port sbit DA_S1 = P2^0; // Control the 8-bit ...[Details]
-
As a power supply device for modern electronic products, the switching power supply not only has to meet the requirements of the power supply equipment, but also has to take its own protection measure...[Details]
-
//Can measure 1MHZ frequency
#include iom8v.h
#include DELAY.H
#define uchar unsigned char
#define uint unsigned int
/***********The corresponding digital tubes display********************/
co...[Details]
-
According to CNBC, on Thursday local time, Trump said in an interview with reporters at the White House that the United States would be very happy to include the recent tough restrictions on Huawei i...[Details]
-
Whether shielded cables must be used for servo encoder cables depends on the specific application scenario and system requirements. In some cases, shielded cables can improve system stability and r...[Details]
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD