Input Characteristics For Enable / Disable Function (Pad 8)
Parameter
Enable Voltage (High) or open circuit
Disable Voltage (Low) Output Tri-stated
(Vih)
(Vil)
Minimum
70% Vcc
-
Nominal
-
-
Maximum
-
30% Vcc
Units
Vdc
Vdc
Notes
10
Input Characteristics For Voltage Control (Pad10)
Parameter
Control Voltage Range (Vcc = 3.3V)
Frequency Tuning
Linearity
Input Impedance
Modulation Bandwidth (3dB)
Slope
(Vc)
Minimum
0.3
±10
±5
100K
10
Nominal
1.65
-
-
-
-
Positive
Maximum
3.0
-
-
-
-
Units
Vdc
ppm
%
Ohm
KHz
Notes
11
LVCMOS Output Characteristics
LOAD
Voltage
(High)
(Low)
Current
(High)
(Low)
Duty Cycle at 50% of Vcc
Rise / Fall Time 10% to 90%
Parameter
(Voh)
(Vol)
(Ioh)
(Iol)
Minimum
-
90%Vcc
-
-4
-
45
-
Nominal
15
-
-
-
-
50
-
Maximum
-
-
10%Vcc
-
4
55
8
Units
pF
Vdc
Vdc
mA
mA
%
ns
Notes
12
Clipped Sinewave Output Characteristics
Load
Output Load Resistance
Output Load Capacitance
Output Voltage (< 40 MHz)
Output Voltage (> 40 MHz)
Notes:
1.
Frequency stability vs. change in temperature. [±(Fmax – Fmin)/2.Fo].
2.
Inclusive of frequency stability, supply voltage change (±1%), aging, for 24 hours.
3.
Over twenty years
4. TCXO: Initial calibration @ 25°C. Specifications at time of shipment after 48 hours of operation.
5. Frequency change after reciprocal temperature ramped over the operating range. Frequency measured before and after at 25°C.
6 Inclusive of calibration @ 25°C, frequency vs. change in temperature, change in supply voltage (±5%), load change (±5%), reflow soldering process
and 20 years aging.
7. For best in application performance, careful selection of an external power source is critical. Select an external regulator that meets or exceeds to
following specifications regarding voltage regulation tolerance, initial accuracy, temperature coefficient, voltage noise, and low voltage noise density
Factory Test Conditions:
Initial Accuracy ±2mv, Noise (0.1Hz to 10 KHz) 15uV p-p, Voltage Noise Density = 50nV/srt Hz, Temperature Coefficient
< 5ppmºC.
8. Phase noise measurements Fo = 20 MHz, other frequencies may vary by 20log F/20MHz.
9. Typical start up time for the frequency range of 12.8 MHz to 25 MHz <330 us.
10. Leave Pad 8 unconnected if enable / disable function is not required. When tri-stated, the output stage is disabled but the oscillator and compensation
circuit are still active (current consumption < 1mA).
11. Additional pull ranges are available; please contact the factory for additional information.
12.
Attention: To achieve optimal frequency stability, and in some cases to meet the specification stated on this data sheet, it is required that the circuit connected to this TCXO output
must have the equivalent input capacitance that is specified by the nominal load capacitance. Deviations from the nominal load capacitance will have a graduated effect on the stability
Thank you for having you +EEWORLDI have been associated with EEWORLD for many years, and I can say that eeworld has helped me a lot. Technology is developing rapidly, and new products and technologies...
Serial port printout before Neptune is burned:1. Burn the firmware using SecureCRT:Use the " SecureCRT " tool to burn the firmware, double-click: " SecureCRTPortable.exe ", as shown below:When you ope...
[size=4]First, the design concept of the instruction set is introduced. Because we want to introduce why ARM adopts the improved RISC instruction set design concept, this part mainly analyzes the diff...
Out of Box is the unboxing routine of CC3200 LaunchPad
Through HTTP Server, the client can control the LED light on the board, read the temperature sensor on the board, and detect the status of the ac...
[i=s] This post was last edited by qwqwqw2088 on 2018-11-13 08:40 [/i] [size=4]1. Fault characteristics and repair of capacitor damage on industrial control circuit boards [/size] [size=4]Faults cause...
[i=s]This post was last edited by damiaa on 2019-1-18 15:36[/i] [NXP Rapid IoT Evaluation] Rapid IoT Studio Counter with Bluetooth Output[size=2] Name: Multi-channel Counter with Bluetooth Output Coun...
According to foreign media reports on February 15, BMW announced on Tuesday local time that it will cooperate with its parts supplier Valeo to develop an autonomous parking system called "Automated V...[Details]
According to Jiwei.com, industry sources said that due to rising wafer foundry costs, PC processor prices are expected to rise sharply in 2022, especially processors manufactured using process nodes ...[Details]
1. Instrument name and model Agilent N5181A signal source 2. Fault phenomenon: The screen does not light up after the instrument is turned on 3. Detailed explanation of inspection and maintenance...[Details]
1. Background
A recent project requires the use of STM32F103xx to implement CAN communication, and the message filtering of the CAN bus has different mechanisms on each MCU.
For example, ...[Details]
The modulation and demodulation capability of CDMA2000 products is a key parameter to ensure their quality. There are many test items related to modulation and demodulation. Below we take the CDMA...[Details]
China's auto industry continues to hold the top spot in global auto production and sales, but a series of social problems follow: the country's dependence on foreign crude oil exceeds the internati...[Details]
On January 8, 2024, the Zhumadian Municipal Development and Reform Commission issued the "Zhumadian New Energy Storage Development Plan" (draft for comments). It is clear that by 2025, the scale of...[Details]
Oscilloscope storage and storage depth When selecting an oscilloscope, engineers first need to determine the bandwidth required for measurement. However, once the bandwidth of the oscilloscope is...[Details]
1 Introduction
With the continuous development of high-voltage and high-power power electronic devices, the driving power supplies connected in series often need to withstand extremely high wo...[Details]
Not long ago, Qualcomm China announced that it will hold the Snapdragon Technology Summit on December 1, when the new generation of Snapdragon mobile platform will be officially released. It ...[Details]
Chip company stock prices have performed poorly over the past few months. A recent report from Deutsche Bank predicted that this earnings season could show more signs of weakness. However, Qualcom...[Details]
NavInfo released an announcement regarding its wholly-owned subsidiary JieFa Technology obtaining an invention patent certificate. The announcement shows that recently, Hefei Jiefa Technology Co., Lt...[Details]
German patent data company IPlytics regularly publishes 5G SEP (standard essential patent) rankings, which has aroused the industry's attention and discussion on the number, quality and value of pate...[Details]
Orifice flowmeter (also known as throttling device, differential pressure flowmeter) is a differential pressure generating device for measuring flow. It is used with various differential pressure gaug...[Details]
By utilizing the comparative characteristic design of the operational amplifier input, an operational amplifier fast tester is made, which can quickly and accurately determine the quality of the oper...[Details]