Regarding the loop compensation part in the DCDC current control mode, if I want to design a switching power supply, do I have to study this part thoroughly? This part feels a bit too difficult. I don...
I originally planned to use pyqt or pyside for programming, but I tried many methods and couldn't get it done. Finally, I tried it successfully with tkinter. Now I share it as follows:
1. Install tkin...
As an industry event, the STMicroelectronics Industrial Summit will provide a platform for leaders from the industrial market to exchange ideas and promote innovative development. The main agenda of t...
eric_wangST Sensors & Low Power Wireless Technology Forum
I want to use a 4.2V lithium battery to drive a two-phase four-wire stepper motor. I would like to ask experts to recommend a driver chip. I tried to use two MAX612E chips to drive one phase each, but...
A module I made recently is to convert the TTL level of the serial port of the microcontroller into 232 level using a 232 chip. After the 232 level is sent out, the receiver uses the 232 chip to conve...
[i=s]This post was last edited by btty038 on 2022-7-18 10:03[/i]What is Gallium Nitride?Gallium Nitride is a binary III/V direct bandgap semiconductor that is well suited for high-power transistors ca...