EEWORLDEEWORLDEEWORLD

Part Number

Search

OC-160-CAB-109BF-12.8MHZ

Description
HCMOS Output Clock Oscillator, 12.8MHz Nom,
CategoryPassive components    oscillator   
File Size60KB,2 Pages
ManufacturerMicrosemi
Websitehttps://www.microsemi.com
Download Datasheet Parametric View All

OC-160-CAB-109BF-12.8MHZ Overview

HCMOS Output Clock Oscillator, 12.8MHz Nom,

OC-160-CAB-109BF-12.8MHZ Parametric

Parameter NameAttribute value
MakerMicrosemi
Reach Compliance Codecompli
Ageing1 PPM/YEAR
Frequency Adjustment - MechanicalNO
frequency stability0.001%
Frequency Stability - Voltage0.002 ppm
input power2.5 W
Installation featuresTHROUGH HOLE MOUNT
Nominal operating frequency12.8 MHz
Maximum operating temperature50 °C
Minimum operating temperature
Oscillator typeHCMOS
Output load100 KOHM, 15 pF
Oven power supply voltage5V
physical size35.3mm x 26.9mm x 19.4mm
Nominal supply voltage5 V
surface mountNO
Oven Controlled Crystal Oscillators (OCXO’s)
OC-160 Series (CO-730C)
Description:
The OC-160 Series offers low aging and excellent stability
options with quick warm-up performance with a standard
European CO-08 footprint.
Features:
Frequencies: 5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz
European CO-08 Package
Excellent Temperature Stability
Superior Aging Characteristics
Very Fast Warm-up
Performance Characteristics
Parameter
Standard
Frequencies:
Package Size:
Supply Voltage:
Input Power:
Output Type:
Output Level (HCMOS):
Rise/Fall Time tr/tf (HCMOS):
Symmetry (Duty/Cycle,HCMOS):
Harmonics/subs:
Spurious:
Temperature Stability:
Characteristics
5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz, Available 1 MHz to 80 MHz
35.3 x 26.9 x 19.4 mm (1.4” x 1.06” x 0.76”)
A:
15 Vdc ±5%
B:
12 Vdc ±5%
C:
5 Vdc ±5%
<6W turn-on (-20
o
C/70°C);
A:
HCMOS
<2.5W steady-state @ +25°C (-20°C/70°C)
K:
Sinewave ( >+10 dBm into 50 ohm)
Aging:
Short Term Stability (Allan Deviation):
Phase Noise (Typical @ 10 MHz):
Frequency vs. Supply:
Warm-up (Restabilization):
(Frequency relative to two hours after
turn-on following 24 hours off time
at +25
o
C with a maximum ambient
of <70
o
C)
Electrical Frequency Adjust:
Mechanical Configuration:
J:
Sinewave ( >+7 dBm into 50 ohm)
L:
Sinewave ( >+13 dBm into 50 ohm)
“0” <0. 5V, “1” >4.5V
(HCMOS)
<10 ns (10% - 90%)
(HCMOS)
50/50 ±10% (@50% level)
(HCMOS)
-20 dBc (reduced level sinewave, for optional output)
-70 dBc (for sinewave output)
B-308:
±3 x 10
-8 over
0/50°C
B-109:
±1 x 10
-9 over
0/50°C
D-508:
±5 x 10
-8 over
-20/70°C
D-509:
±5 x 10
-9 over
-20/70°C
Note: Tighter stability options
F-107:
±1 x 10
-7 over
-40/85°C
are available, contact factory.
F-108:
±1 x 10
-8 over
-40/85°C
A:
1 x 10
-8
/day, 2x10
-6
/year
B:
3 x 10
-9
/day, 1x10
-6
/year
C:
1 x 10
-9
/day, 3x10
-7
/year
D:
5 x 10
-10
/day, 1x10
-7
/year
5 x 10
-11
/second (with aging
A
or
B);
5 x 10
-12
/second (with aging
C
or
D)
With Aging:
A or B
Aging: C or D
10 Hz
-100 dBc/Hz
-120 dBc/Hz
100 Hz
-135 dBc/Hz
-140 dBc/Hz
1 kHz
-145 dBc/Hz
-145 dBc/Hz
10 kHz
-150 dBc/Hz
-150 dBc/Hz
50 kHz
-150 dBc/Hz
-150 dBc/Hz
2 x 10-9 per % change in supply (with Aging
A
or
B)
5 x 10-10 per % change in supply (with Aging
C
or
D)
With Aging:
A or B
Aging: C or D
-6
: 6 minutes 1 x 10
-6
: 2 minutes
1 x 10
1 x 10
-7
: 8 minutes 1 x 10
-7
: 2.5 minutes
3 x 10
-8
: 10 minutes 3 x 10
-8
: 3 minutes
3 x 10
-8
: 30 minutes 1 x 10
-8
: 4 minutes
10 x 10-6 typical range (with Aging
A or B)
2 x 10-6 typical range (with Aging
C
or
D)
Pins for PCB mounting
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Web: www.vectron.com
46
[Review of SGP40] + Testing the sensor I2C communication with Arduino
[i=s]This post was last edited by damiaa on 2021-3-2 08:43[/i][Review of SGP40] + Testing the sensor I2C communication with Arduino It was easy to test SVM40 I2C communication with Arduino, but it too...
damiaa Sensor
Analysis of the causes of high temperature failure of DCDC power modules
1. The dcdc power module is a switching power supply that uses power semiconductor switching devices to achieve dcdc power conversion. It is widely used in remote and data communications, computers, o...
fish001 Analogue and Mixed Signal
Near Field Communication (NFC) Transceiver Reference Design
This Near Field Communication (NFC) reference design outlines the required components and layout considerations, and provides firmware examples to illustrate how to implement NFC into an application t...
Jacktang RF/Wirelessly
In electromagnetic field simulation, what are the advantages and disadvantages of FDTD and FEM algorithms?
[p=null, 0, center][color=rgb(62, 62, 62)][font=-apple-system-font, BlinkMacSystemFont, "][size=17px][/size][/font][/color][/p] [p=null, 2, left][color=rgb(62, 62, 62)][font=-apple-system-font, BlinkM...
btty038 RF/Wirelessly
Combining 51 code to analyze the programming ideas of RFID card reader
In this RFID module, the platform is based on the 51 single-chip microcomputer for beginners. Let’s summarize what we have gained from writing the code.   Software design of the card reader: It seems ...
fish001 RF/Wirelessly
X-NUCLEO-IKS01A3 sensor driver transplantation based on STM8S-DISCOVERY
[i=s]This post was last edited by sylar^z on 2019-7-30 17:43[/i]This porting of the X-NUCLEO-IKS01A3 sensor driver is based on the STM8S-DISCOVERY development board, using the official en.x-cube-mems1...
sylar^z ST Sensors & Low Power Wireless Technology Forum

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号