1. What is the DSP power-on reset configuration? The DSP big-endian, little-endian, self-starting (boot) mode, PCIe mode, and network coprocessor clock selection need to be selected at power-on reset....
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:57[/i] Signal isolation allows digital or analog signals to be transmitted without a galvanic connection across the barrier between the...
Within the SimpleLink platform, you have access to a variety of hardware tools, including the TI LaunchPad development kit and our new LaunchPad SensorTag kit. At the heart of each kit is the SimpleLi...
As shown in the figure: Multisim is used to simulate the voltage doubler rectifier circuit, with a transformation ratio of 20. According to the principle, if the voltage between C6 and the ground is t...
[i=s]This post was last edited by liuyongsuse on 2020-12-6 00:55[/i]You can build a Docker image by automatically generating a Dockerfile through the configuration of pom.xml without Dockerfile. The D...
For example, if an RTD with a temperature range of -50-200 degrees is set to 260 degrees, will the RTD be physically damaged or is it just out of the linear range?...