5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
2
I C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
2
I C Timing Specification ...................................................................................................................................................... 31
2
I C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.05
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
[i=s]This post was last edited by Capacitor on 2018-9-10 10:35[/i] [align=center][/align] Non-invasive Optical Plethysmography-Pulse Oximeter using MSP430FG437 Microcontroller (MCU). The pulse oximete...
1. Knowledge point - K210 chip OnSeptember 6, 2018, Canaan Technology launched the world's first mass-produced commercial edge intelligent computing chip based on RISC-V, the K210, which was independe...
This book explains in detail the hardware structure, working principle, resource allocation, functional characteristics and application of each functional module inside the TMS320F28335 DSP processor....
[i=s]This post was last edited by allenliu on 2019-1-21 00:45[/i] I got the board in the first batch of the review activity. The packaging is good. The box is easy to open quickly and uses magnetic su...
To test the quality of a bidirectional thyristor with a multimeter, you must first distinguish the control electrode G and the main electrodes T1 and T2 of the bidirectional thyristor. Set the multim...[Details]
As Apple's stock price continues to rise, its market value is getting closer and closer to $2 trillion, with the highest market value reaching $1.98 trillion. That is to say, it is only about $20 bil...[Details]
RTI, the largest software framework provider for intelligent machines and applications, recently announced that it has joined the Autoware Foundation, an open alliance for autonomous driving technolo...[Details]
Special registers used:
SM0 SM1: Operation mode control 01 Operation mode 1 1 start bit 8 data bits 1 stop bit Variable baud rate
TI: Transmit interrupt bit TI=1 Transmitting is completed, sof...[Details]
Today we will explain an important concept of frequency converter: frequency source. Some brands also call it given channel, etc., but they are all the same thing. Previously, as long as a running ...[Details]
Let me start with a sentence: The wave of digital power supply is here! However, some technical issues about the design and implementation of digital power supply are not only discussed by so-calle...[Details]
Turn on the AFIO clock. External interrupt, remapping, multiplexing function? When configuring the values in the six AFIO registers, you need to turn on the AFIO clock. void EXTI0_Config(void) ...[Details]
Recently, He Xiaopeng, Chairman of Xpeng Motors, responded to the progress of Robotaxi business and said that he would focus on the Robotaxi product itself, not on the operation, and focus on how t...[Details]
Samsung Electronics' autumn flagship Galaxy Note10 has officially gone on sale in South Korea, with pre-orders breaking the record by reaching 1.3 million units. It is expected that sales will exceed...[Details]
They are friends and partners who have created the myth of the hot-selling Model 3 ( lithium iron phosphate version). They are also enemies and competitors . The battle over the power battery route w...[Details]
In the face of serious problems such as energy shortage and climate warming, humans have turned to finding and using clean energy technologies for survival and development. Clean energy includes solar...[Details]
Siemens 200PLC and Easy Control INSPEC software are connected to Siemens S7200 series PLC via Ethernet. Xingda Easy Control PPI-ETH-XD1.0 communication module is used to provide Ethernet communicat...[Details]
High-voltage soft start cabinet is a device used for high-voltage motor starting. Its main function is to reduce the current impact when the motor starts and extend the service life of the motor. T...[Details]
ARM Technology
京公网安备 11010802033920号
EEWORLD
