Preliminary
SF1056B
•
•
•
•
110.592 MHz Narrow-band SAW Filter
Steep Transition to Stopband
Hermetic 5 X 7 mm Surface Mount Case
Complies with Directive 2002/95/EC (RoHS)
Pb
110.592 MHz
SAW Filter
Value
+10
3
-40 to +80
-40 to +85
Absolute Maximum Ratings
Rating
Incident Power in Passband
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Soldering Profile, 5 Cycles Maximum
Units
dBm
VDC
°C
°C
265 °C for 10 s
SMP-03
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss
3 dB Bandwidth
Group Delay Ripple, 110.016 to 111.168 MHz
40 dB Bandwidth
Rejection:
DC to 107.192 MHz
107.192 to 108.864 MHz
112.320 to 113.992 MHz
113.992 to 200 MHz
Source Impedance for L-L Matching Network
Load Impedance for L-L Matching Network
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) See note 3
38
28
28
38
42
42
34
42
50
50
SMP-03 5 x 7 mm Nominal Footprint
RFM SF1056B YWWS
ohm
ohm
dB
BW
40
Sym
F
C
IL
BW
3
Notes
Min
Typ
110.592
8.6
Max
10.0
200
7.0
Units
MHz
dB
MHz
ns
P-P
MHz
1.152
1.44
150
6.7
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer. A
dB offset exists for RFM because of the loss introduced by using trans-
formers on the Input and Output.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
"LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
4.
5.
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
2.
6.
7.
3.
www.RFM.com E-mail: info@rfm.com
©2011 by RF Monolithics, Inc.
Page 1 of 5
SF1056B - 3/16/11
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
