By combining power delivery and communications over a single Cat3 or Cat5 cable, engineers can quickly build Ethernet networks at a lower cost and with less maintenance than would be possible with sep...
Without impedance control, it will cause considerable signal reflection and signal distortion, leading to design failure. Common signals, such as PCI bus, PCI-E bus, USB, Ethernet, DDR memory, LVDS si...
Many desktop computers do not have wireless network cards and can only be plugged in with a network cable.
If you want to use WiFi, just plug in a USB wireless network card, it's simple and convenient...
5G millimeter wave antenna
One of the characteristics of 5G antennas is the use of MIMO and beamforming technology. How to integrate these two technologies was once a headache for RD personnel until t...
[i=s]This post was last edited by Hot Ximixiu on 2020-7-5 10:44[/i]The MSP430 series microcontroller is a new generation of 16-bit microcontroller produced by TI in the United States. It is an ultra-l...
For SPI communication, there are only four pins: MOSI, MISO, CS, and CLK. SPI has four modes. So how do you set the various modes when using SPI? There are no clock polarity and phase pins?...