High Reliability KEMET Organic Capacitor (KO-CAP) – T541 Polymer Commercial Off-the-Shelf (COTS) Multiple Anode Series
Ordering Information
T
Capacitor
Class
T=
Tantalum
541
Series
541 =
Polymer
COTS
Multiple
Anode
D
Case
Size
D, X,
Y
157
Capacitance
Code (pF)
First two digits
represent
significant
figures. Third digit
specifies number
of zeros.
M
Capacitance
Tolerance
M = ±20%
10
Voltage
2R5 = 2.5 V
003 = 3 V
004 = 4 V
006 = 6.3 V
010 = 10 V
016 = 16 V
020= 20 V
025 = 25 V
035 = 35 V
050 = 50 V
063 = 63 V
A
H
65
10
ESR
10 = ESR -
Standard
20 = ESR -
Low
30 = ESR -
Ultra Low ESR
Packaging
(C-Spec)
Blank = 7"
Reel
7280 = 13"
Reel
Failure Rate/
Lead Material Surge Option
Design
A = N/A
H = Standard
Solder
Coated
(SnPb 5% Pb
minimum)
65 = No
Surge
66 = 10
cycles @
25°C
67 = 10
cycles -55°C
and 85°C
Applications
Typical applications include decoupling and filtering in defense
and aerospace applications that require low ESR or a benign failure
mode.
Performance Characteristics
Item
Operating Temperature
Rated Capacitance Range
Capacitance Tolerance
Rated Voltage Range
DF (120 Hz)
ESR (100 kHz)
Leakage Current
-55°C to 125°C *
10 – 1,500 µF @ 120 Hz/25°C
M Tolerance (20%)
2.5 – 63 V
10%
Refer to Part Number Electrical Specification Table
≤ 0.1C V (µA) at rated voltage after 5 minutes
Performance Characteristics
* KEMET’s Polymer COTS (T540/T541 Series) capacitors are rated for operation between -55°C and +125°C. Parametric electrical performance remains within
stated specification limits after 1,000 hours of continuous operation and/or storage at +125°C. Long-term duty cycles or storage at or above +125°C may result in
an increase in ESR performance outside of the stated specification limits.
High Reliability KEMET Organic Capacitor (KO-CAP) – T541 Polymer Commercial Off-the-Shelf (COTS) Multiple Anode Series
Electrical Characteristics
ESR vs. Frequency
10
T541X227M016AHE040_Imp
T541X227M016AHE040_ESR
T541X107M020AHE050_Imp
1
T541X107M020AHE050_ESR
T541X107M025AHE060_Imp
T541X336M050AHE075_Imp
T541X336M050AHE075_ESR
0.1
T541X107M025AHE060_ESR
1,000
T541X227M016AHE040
T541X107M020AHE050
T541X107M025AHE060
T541X336M050AHE075
Capacitance vs. Frequency
Impedance & ESR (Ohms)
Capacitance (µF)
100
0.01
0.001
10
100
1,000
10,000
Frequency (Hz)
100,000
1,000,000
10,000,000
100
1,000
10,000
Frequency (Hz)
100,000
1,000,000
10,000,000
Dimensions – Millimeters (Inches)
Metric will govern
Termination
cutout at
KEMET’s
option,
either end
Case Size
KEMET
D
X
Y
EIA
7343–31
Component
L*
W*
H*
F* ±0.1 S* ±0.3 B* ±0.15
±(0.004) ±(0.012) (Ref) ±0.006
1.3 (.051)
1.3 (.051)
1.3 (.051)
0.5 (.020)
0.5 (.020)
0.5 (.020)
X (Ref)
0.10 ±0.10
(.004 ±0.004)
0.10 ±0.10
(.004 ±0.004)
0.10 ±0.10
(.004 ±0.004)
P (Ref)
0.9 (.035)
1.7 (.067)
1.7 (.067)
R (Ref)
1.0 (.039)
1.0 (.039)
1.0 (.039)
T (Ref)
0.13 (.005)
0.13 (.005)
0.13 (.005)
A (Min) G (Ref) E (Ref)
3.8 (.150)
3.8 (.150)
3.8 (.150)
3.5 (.138) 3.5 (.138)
3.5 (.138) 3.5 (.138)
3.5 (.138) 3.5 (.138)
7.3 ±0.3
4.3 ±0.3
2.8 ±0.3
2.4 (.095)
(0.287 ±0.012) (0.169 ±0.012) (0.110 ±0.012)
7.3 ±0.3
4.3 ±0.3
4.0 ±0.3
7343–43
2.4 (.095)
(0.287 ±0.012) (0.169 ±0.012) (0.157 ±0.012)
7.3 ±0.3
4.3 ±0.3
4.0 (.157)
7343–40
2.4 (.095)
(0.287 ±0.012) (0.169 ±0.012) Maximum
Notes: (Ref) – Dimensions provided for reference only. No dimensions are provided for B, P or R because low profile cases do not have a bevel or a notch.
Because NXP's MAG3110 was discontinued, there was a shortage of microbit some time ago. Now the new version of microbit uses ST's LGM303A, which combines the acceleration and magnetic field sensors in...
dcexpertST Sensors & Low Power Wireless Technology Forum
I think it should be VICR, i.e. the common-mode input voltage range, but my colleague told me it should be the value of the black circle in the VOH row, VCC-1.5, which I don't quite understand. Also, ...
Transistors are the most commonly used basic knowledge of analog circuits. Transistors are semiconductor components that are widely used in circuit design. If you don’t know how to use transistors, yo...
FRAM, also known as Ferroelectric Random Access Memory, is a memory technology that combines the non-volatility of Flash with the flexibility and low power consumption of SRAM. MSP430 ultra-low-power ...
[size=4] The voltage gain of the voltage follower is one, so it is called a voltage follower. It is a common collector circuit composed of a triode. The signal is input from the base and output from t...
Serial port monitoring dataHow do you monitor the data between two serial ports (such as the serial port of the main control MCU and the serial port of the Bluetooth chip )? I downloaded a serial port...
The application of frequency conversion technology is very wide, such as frequency conversion air conditioners, frequency conversion heat pumps, frequency conversion floor heating, frequency conver...[Details]
LED luminous efficacy continues to improve. In order to achieve high brightness requirements, the power of a single component has also increased significantly, especially the high heat caused by op...[Details]
Abstract: The internal structure and working principle of the graphic dot matrix liquid crystal display module LCD240128A are analyzed. The interface circuit between the MPU and the liquid cryst...[Details]
The design is based on 51 single-chip microcomputer and uses 1602 LCD for display. The frequency measurement method uses equal-precision frequency method. The external pulse is used as the start sign...[Details]
A high-reliability linear regulator usually requires a current limiting protection circuit to prevent permanent damage to the regulator due to load short circuit or overload. Current limiting pro...[Details]
The impact of series and parallel connection of
LED lamps
on lamp life
There are basically four common LED
arrangement structures
on light source panels
. Below we will explain the rel...[Details]
Foreign media Svetapple.sk reported that the aluminum chassis of some iPhone 12 models have lost color, including photos of a PRODUCT (RED) iPhone 12 model, which has obvious color bleeding. ...[Details]
According to the main types and performance of typical mainstream products of electromagnetic flowmeters, the selection has the following requirements: (1) Measured medium: Fluid electromagnetic fl...[Details]
The use of matrix keyboards is very common in the study of single-product machines, but for many novices, including myself, sometimes I don’t understand it. After thinking about it last night and thi...[Details]
Generally, LC oscillators are suitable for higher frequencies. When the frequency is lower, RC oscillators with resistors and capacitors as the frequency selection network are often used.
...[Details]
In this article, we will investigate the benefits of using SiC technology for EV traction inverters. We will show how inverter efficiency is improved under a variety of load conditions, from light ...[Details]
With the in-depth integration of the new generation of information technology and manufacturing, the manufacturing industry has undergone tremendous changes, gradually shifting from quantity expans...[Details]
At present, most of the high-pressure injection water metering in the high-pressure injection system of oil fields is dry-type high-pressure water meter. The dry-type water meter has the characteristi...[Details]
We know that OD (object dictionary) is the core of CANopen. All functions are carried out around it. It is the data center of the protocol stack. Good OD implementation is the basis for the efficient...[Details]
The domestic automotive-grade Hall current sensor CH704 is an isolated integrated current sensor chip developed for large current detection applications above 50A. It has the advantages of high pre...[Details]
ST Sensors & Low Power Wireless Technology Forum
京公网安备 11010802033920号
EEWORLD
