MQME series filters (with MQFL converters) are designed to meet:
• MIL-HDBK-704-8 (A through F)
• RTCA/DO-160E Section 16
• MIL-STD-1275B
• DEF-STAN 61-5 (part 6)/5
• MIL-STD-461 (C, D, E)
• RTCA/DO-160E Section 22
www.synqor.com
Doc.# 005-0005135 Rev. A
03/18/09
Page 1
MQME-28E-P
Current:
20A
Technical Specification
BLOCK DIAGRAM
TYPICAL CONNECTION DIAGRAM
Product # MQME-28E-P
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-0005135 Rev. A
03/18/09
Page 2
MQME-28E-P
Current:
20A
Technical Specification
MQME-28E-P ELECTRICAL CHARACTERISTICS
Parameter
ABSOLUTE MAXIMUM RATINGS
Input Voltage
Continuous
Transient (≤1 s)
Isolation Voltage (I/O to case)
Continuous
Transient (≤1 s)
Output Current
Operating Case Temperature
Storage Case Temperature
Lead Temperature (20 s)
ELECTRICAL CHARACTERISTICS
Input Voltage
Continuous
Transient (≤1 s, R
S
* = 0 Ω)
Transient (≤100 ms, R
S
* = 0 Ω)
Output Voltage (continuous)
Output Current (continuous)
DC Resistance R
DC
TCASE = 25°C
TCASE = 125°C
Power Dissipation (20A output current)
TCASE = 25°C
TCASE = 125°C
Total Differential-Mode Capacitance
Total Common-Mode Capacitance
Bulk Capacitor
Damping Capacitor
Noise Attenuation
INPUT VOLTAGE SPIKE SUPPRESSION
Output Voltage Deviation due to a Spike
2
Input Voltage Spike (Centered on V
in
)
±600V, 10µs, R
s
= 50Ω
ISOLATION CHARACTERISTICS
Isolation Voltage (any pin to case)
Continuous
Transient (≤ 100 µs)
Isolation Resistance (any pin to case)
* R
s
= Source Impedance
Product # MQME-28E-P
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-0005135 Rev. A
03/18/09
Page 3
Min. Typ.
Max.
Units Notes & Conditions
Vin=28V DC ±5%, Iout= 20A unless otherwise specified
Subgroup
3
Group A
See Note 1
-100
-200
-500
-1000
-55
-65
100
200
500
1000
20
125
135
300
V
V
V
V
A
°C
°C
°C
-70
-80
-100
70
80
100
V
V
V
V
A
mΩ
mΩ
W
W
µF
µF
µF
Ω
See Note 1 for negative limits
"
See Note 1
1, 2, 3
Vout = Vin - (Iin
x Rdc)
20
25
35
10
14
71
0.28
58
0.2
1, 2, 3
1, 2, 3
1
3
1, 2, 3
Measured across input or output pins
Measured between any pin to case
See Figure 1
-5
10
ΔV
RTCA/DO-160E
-500
-800
100
500
800
V
V
MΩ
1
1
MQME-28E-P
Current:
20A
Technical Specification
MQME-28E-P ELECTRICAL CHARACTERISTICS (Continued)
Parameter
RELIABILITY CHARACTERISTICS
Calculated MTBF (MIL-STD-217F2)
GB @ Tcase = 70ºC
AIF @ Tcase = 70ºC
Demonstrated MTBF
WEIGHT CHARACTERISTICS
Device Weight
Electrical Characteristics Notes
1. While the filter will survive these input voltage limits, the filter's output voltage will be outside the limits for an MQFL converter input voltage range.
2. Verified by qualification testing and analysis.
3. Only the ES and HB grade products are tested at three temperatures. The B and C grade products are tested at one temperature. Please refer to the
Construction and Environmental Stress Screening Options table for details.
* R
s
= Source Impedance
79
g
21.7
1.26
TBD
106 Hrs.
106 Hrs.
106 Hrs.
Min. Typ.
Max.
Units Notes & Conditions
Vin=28V DC ±5%, Iout= 20A unless otherwise specified
Subgroup
3
Group A
Product # MQME-28E-P
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-0005135 Rev. A
03/18/09
Page 4
MQME-28E-P
Current:
20A
Technical Specification
Figure 1: Typical Common Mode and Differential Mode Attenuation
provided by the filter as a function of frequency. Both input lines are
connected to chassis ground through 50W resistors. The filter case is
also connected to chassis ground.
Figure 2: Typical Output Impedance (magnitude) of the filter looking
back into its output pins with the input pins connected to a source with
zero source impedance.
Figure 3: MIL-STD-461E Method CE101 Low Frequency Conducted
Emissions. Limit line (in red) is the ‘Submarine Applications DC
Curve’. Setup described on Page 7.
Figure 4: MIL-STD-461E Method CE102 High Frequency Conducted
Emissions. Limit line (in red) is the ‘Basic Curve’. Setup described on
Page 7.
Product # MQME-28E-P
Figure 5: MIL-STD-461E Method RE101 Low Frequency Radiated
Emissions. Limit line (in red) is the ‘Standard Curve’ from MIL-STD-
461C Method RE01, which is more strict than all RE101 limits. Setup
described on Page 7.
Phone 1-888-567-9596
Figure 6: MIL-STD-461E Method RE102 High Frequency Radiated
Emissions. Limit line (in red) is the ‘Submarine External to Pressure
Automatic hovering means fixing the drone at a preset height and horizontal position, which is actually a set of three-dimensional coordinates. But how does a drone know its position? In fact, it is v...
Animation analysis of the working principles of various motors : https://training.eeworld.com.cn/course/5598Animation details the working principles of various motors, three-phase induction motors, se...
Press P2.1, LED1 lights up for 1s, quickly press P2.1 twice, LED2 lights up for 1s// Press P2.1, LED1 lights up for 1s, quickly press P2.1 twice, LED2 lights up for 1s
#include "msp430f5525.h"
unsigne...
I have been unable to figure out this problem recently. Are SWCLK and SWDIO pulled up or down? The pictures are all different and I don’t understand....
Mechanics in Electronic Packaging : https://training.eeworld.com.cn/course/5211Mechanics in Electronic Packaging Liu Sheng, Huazhong University of Science and Technology...
Nandflash chips are widely used in electronic products for their high cost performance and large storage capacity. However, in this large-volume and high-quality application field, many customers are ...
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
