Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level( surge immunity:Line-Line:1KV ),EAC TP TC 020
380.7Khrs min.
MIL-HDBK-217F (25
℃
)
121*77*28.5mm(L*W*H)
0.43Kg; 24pcs/ 11.3Kg/ 0.74CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25
℃
of ambient temperature.
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De-rating may be needed under low input voltages. Please refer to STATIC CHARACTERISTIC sections for details.
4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time or set up failure
5. Aux. 12V will be damaged with short circuit; It will not be available when output voltage is not in constant current region or output no load condition.
6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be
affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
7.The DALI version driver does not support the bit 1: Lamp failure in the Command 144 Query status of the DALI standard.
8. The ambient temperature derating of 3.5
℃
/1000m with fanless models and of 5
℃
/1000m with fan models for operating altitude higher than 2000m(6500ft).
9. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
Block Diagram
ODLC-65
series
fosc : 70KHz
RECTIFIERS
EMI FILTER
&
RECTIFIERS
POWER
SWITCHING
RECTIFIERS
&
FILTER
AUX+(for
ODLC-65A
)
AUX-(for
ODLC-65A
)
Vo+
Vo-
DIM+(DA+)
DIM-(DA-)
I/P
CURRENT
LIMIT
DETECTION
CIRCUIT
O.L.P.
PWM&PFC
CONTROL
DRIVING METHODS OF LED MODULE
※
This series works in constant current mode to directly drive the LEDs.
In the constant current region, the highest voltage at the output of the driver
depends on the configuration of the end systems.
Constant
Current area
Should there be any compatibility issues, please contact MEAN WELL.
100
75
(min.)
Hiccup
Protection
Vo(%)
50
100
Io(%)
Typical output current normalized by rated current (%)
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
DIMMING OPERATION
ODLC-65
series
AUX-(Green)*
AUX+(Yellow)*
Vo-(Black)
Vo+(Red)
DIM- (DA-)(Gray)
DIM+ (DA+)(Purple)
ACN(Blue)
ACL(Brown)
*AUX-/AUX+ only for ODLC-65A
※
2 in 1 dimming function
Output constant current level can be adjusted by applying one of the two methodologies between DIM+ and DIM-:
0 ~ 10VDC, or 10V PWM signal.
Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers.
◎
Applying additive 0 ~ 10VDC
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
Additive Voltage
-
+
-
70%
60%
50%
40%
30%
20%
10%
0%
0V 1V
2V 3V 4V 5V 6V 7V 8V 9V 10V
Dimming input: Additive voltage
DIM-
“DO
NOT connect "DIM- to Vo-"
◎
Applying additive 10V PWM signal (frequency range 300Hz ~ 3KHz):
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
-
70%
60%
50%
40%
30%
20%
Additive PWM signal
DIM-
“DO
NOT connect "DIM- to Vo-"
10%
0%
0% 10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Duty cycle of additive 10V PWM signal dimming input
Note : 1. Min. dimming level is about 8% and the output current is not defined when 0%<
I
out<8%.
2. The output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle.
※
DALI Interface (primary side; for DA-Type)
Apply DALI signal between DA+ and DA-.
DALI protocol comprises 16 groups and 64 addresses.
[align=left]:victory:I don't know if you know that Tektronix has free open labs in many cities for engineers to test. It is said that these open labs are busy, and AEs are sometimes on business trips ...
[i=s]This post was last edited by beyondvv on 2019-3-7 11:55[/i] I suddenly received a courier yesterday. When I opened it, I found it was a pair of Sony headphones sent by EEWORLD. I just happened to...
[backcolor=white][size=4][color=#000000]The source program of the microcontroller is as follows:[/color][/size][/backcolor] [backcolor=white][size=4][color=#000000]//**********************************...
In addition to MicroPython, RPi PICO can also run CircuitPython. Although CircuitPython is not as comprehensive as MicroPython, it has better support for USB and some specific devices. The firmware up...
Test/Measurement
京公网安备 11010802033920号
EEWORLD
