Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level( surge immunity:Line-Line:1KV ),EAC TP TC 020
380.7Khrs min.
MIL-HDBK-217F (25
℃
)
121*77*28.5mm(L*W*H)
0.43Kg; 24pcs/ 11.3Kg/ 0.74CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25
℃
of ambient temperature.
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De-rating may be needed under low input voltages. Please refer to STATIC CHARACTERISTIC sections for details.
4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time or set up failure
5. Aux. 12V will be damaged with short circuit; It will not be available when output voltage is not in constant current region or output no load condition.
6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be
affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
7.The DALI version driver does not support the bit 1: Lamp failure in the Command 144 Query status of the DALI standard.
8. The ambient temperature derating of 3.5
℃
/1000m with fanless models and of 5
℃
/1000m with fan models for operating altitude higher than 2000m(6500ft).
9. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
Block Diagram
ODLC-65
series
fosc : 70KHz
RECTIFIERS
EMI FILTER
&
RECTIFIERS
POWER
SWITCHING
RECTIFIERS
&
FILTER
AUX+(for
ODLC-65A
)
AUX-(for
ODLC-65A
)
Vo+
Vo-
DIM+(DA+)
DIM-(DA-)
I/P
CURRENT
LIMIT
DETECTION
CIRCUIT
O.L.P.
PWM&PFC
CONTROL
DRIVING METHODS OF LED MODULE
※
This series works in constant current mode to directly drive the LEDs.
In the constant current region, the highest voltage at the output of the driver
depends on the configuration of the end systems.
Constant
Current area
Should there be any compatibility issues, please contact MEAN WELL.
100
75
(min.)
Hiccup
Protection
Vo(%)
50
100
Io(%)
Typical output current normalized by rated current (%)
File Name:ODLC-65-SPEC 2018-09-29
65W Constant Current Mode LED Driver
DIMMING OPERATION
ODLC-65
series
AUX-(Green)*
AUX+(Yellow)*
Vo-(Black)
Vo+(Red)
DIM- (DA-)(Gray)
DIM+ (DA+)(Purple)
ACN(Blue)
ACL(Brown)
*AUX-/AUX+ only for ODLC-65A
※
2 in 1 dimming function
Output constant current level can be adjusted by applying one of the two methodologies between DIM+ and DIM-:
0 ~ 10VDC, or 10V PWM signal.
Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers.
◎
Applying additive 0 ~ 10VDC
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
Additive Voltage
-
+
-
70%
60%
50%
40%
30%
20%
10%
0%
0V 1V
2V 3V 4V 5V 6V 7V 8V 9V 10V
Dimming input: Additive voltage
DIM-
“DO
NOT connect "DIM- to Vo-"
◎
Applying additive 10V PWM signal (frequency range 300Hz ~ 3KHz):
100%
90%
80%
Output current (%)
Vo+
Vo-
DIM+
+
-
+
-
70%
60%
50%
40%
30%
20%
Additive PWM signal
DIM-
“DO
NOT connect "DIM- to Vo-"
10%
0%
0% 10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Duty cycle of additive 10V PWM signal dimming input
Note : 1. Min. dimming level is about 8% and the output current is not defined when 0%<
I
out<8%.
2. The output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle.
※
DALI Interface (primary side; for DA-Type)
Apply DALI signal between DA+ and DA-.
DALI protocol comprises 16 groups and 64 addresses.
The salesperson went to discuss a case. They wanted to place the equipment 15 meters under the sea water and transmit the data to the receiver on the surface through RS485 communication. The equipment...
[i=s]This post was last edited by yanxinboy on 2020-9-25 20:20[/i]It’s very busy before the holidays and at the end of the month!The CH579 integrates a 12-bit successive approximation analog-to-digita...
Segger's linker is fast, flexible, easy to use, supports Cortex-M microcontrollers, and is designed specifically for the needs of embedded developers. The instructions of its linker script file are si...
The chip analyzed this time is LPS22HH, the interface is still IIC, the driver is still the original one, first experiment to read the ID;uint8_t LPS22HH_Read_Date(uint8_t SlaveAddress, uint8_t RegAdd...
Opening remarks
I was supposed to finish the OTA review of CH579 in 2020, but I am a lazy person and I am reluctant to put down the "King of Pesticides" until now. . .
Without further ado, let’s get t...
To use the RTE environment to build RL-USB or RL-TCPnet or CMSIS-Driver -SPI/CAN; then the basic code must be added, otherwise the code generated by RTE cannot be usedAs shown in the picture, the repe...
Apple officially released the new iPhone 12 series 5G products on Wednesday, including iPhone 12 mini, iPhone 12, iPhone 12 Pro and iPhone 12 Pro Max. Among them, iPhone 12 and iPhone 12 Pro...[Details]
With the modular development of hardware systems, many electronic products have been made into modules and use serial ports for data communication. For example: GPRS module, GPS module, voice module, ...[Details]
Imagine an orange cat, then imagine that cat is coal grey, and now imagine that cat striding along the Great Wall. When you imagine this, a series of neurons in your brain fire quickly, and based on ...[Details]
ARM storage system: System control coprocessor CP15 for storage management in ARM: Contains 16 32-bit registers, numbered 0 to 15. In fact, there may be multiple physical registers corresponding to s...[Details]
BIC: ARM instruction, clear some bits to zero. First invert and then AND.
asm("BIC r2, r2, #0x1f"); ##Clear the lower 5 bits of R2.
ORR: ARM instruction, logical OR
asm("ORR r2,...[Details]
1 Introduction
ARM has 7 operating modes, and the stack pointer register (SP) of each mode is independent.
Therefore, for each processor mode needed in the program, a stack address must be defined ...[Details]
Introduction Some sensor signal conditioners process the outputs of multiple sensor elements. This processing is usually done by multimodal, mixed-signal conditioners that process the outputs of sev...[Details]
On March 15, according to DIGITIMES, Lee Biing-jye, chairman of Ennostar, the parent company of Taiwan's Epistar, said that Epistar, a manufacturer of LED epitaxial wafers and chips, is building a Mi...[Details]
MOSFET can be roughly divided into the following categories: planar MOSFET; Trench MOSFET, mainly used in low voltage fields; SGT (Shielded Gate Transistor, shielded gate trench) MOSFET, mainly ...[Details]
Car theft is a critical issue for drivers. EU law enforcement authorities recorded 447,700 car thefts in 2020 . The FBI reported that 810,400 vehicles were stolen across the United States in 2020, wh...[Details]
I checked a lot of information on the Internet, referred to others', and combined it with some of my own problems. The content is directly reproduced here for the same people as me. For beginners w...[Details]
As an authorized distributor of TE Connectivity, Heilind can provide relevant product services and support to the market. It also supplies products from many of the world's top manufacturers, coverin...[Details]
In the existing automobile market, many brands and models are widely recognized for their excellent safety performance. These brands and models have performed well in safety technology, crash test ...[Details]
Power technology
京公网安备 11010802033920号
EEWORLD
